Rena Ware AQUA NANO UCU LX-500 Uso Y Mantenimiento página 7

6. Attaching installation assembly:
a. Install two new, high quality, AA batteries (not included) in the Filter
Base. Insert the Data Cable into the Data Cable Port on the underside of
the base.
IMPORTANT: When the batteries are installed, the replacement lights
will fire a test sequence. If all lights do not light, you may have a broken
wire on installation.
data
cable
data
cable
port
b. Insert the Inlet Tube-to-Faucet Outlet
Connector (6) into the end of the Spout Outlet
Tube (the shorter tube without red tape).
12
c. Insert the Inlet Assembly tube (9) into the other end of
the Inlet Tube-to-Faucet Outlet Connector (6).
d. Insert the Spout Inlet Tube (marked with the
Red tape) into the narrower end of the Outlet
Tube-to-Faucet Connector (5).
e. Insert one end of the Outlet Extension Tube (3) into the open
end of the Outlet Tube-to-Faucet Connector (5). Make sure the
Outlet Extension Tube is inserted all the way into the connector.
13
EN