Setup Instructions - Polygroup SUMMER WAVES GLO PARTY POOL El Manual Del Propietario

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING
- DO NOT overfill the pool and / or allow people to lay over or sit on pool wall - DOING SO CAN CAUSE PERMANENT INJURY!
DRAIN pool to the proper level after a heavy rain.
TIP:
It will be much easier to install your pool if you unfold it and let it lay in direct sunlight for about 2 hours prior to installation. This will help to insure a
wrinkle-free fit because the pool material will be more pliable allowing it to form into shape during installation.
WARNING
- VERY IMPORTANT! SITE MUST BE LEVEL, STABLE, COMPACTED SOIL.
• The pool must be assembled on a smooth and level site of firm soil that is free of stones, gravel, sticks, blacktop, or other oil base compounds.
• Before setting up your pool, it is recommended that you clear the area of hardy grasses. Certain types of vigorous grasses such as St. Augustine and
Bermuda can grow through the liner. A ground cloth or tarp may be helpful in preventing this from occurring.
• Do not install pool on a wooden deck or any type of wooden surface. You cannot use SAND and/or uncompacted soil to provide a level surface for this pool;
it will only wash out.
1. Select a level area, and completely remove all debris, twigs, stones, etc. DO NOT select an area under over head electrical lines, trees or within 15 feet of a house,
building, etc.
2. The pool shall be located a minimum distance of 6ft (1.83m) from any electrical receptacle.
3. All 125 volt, 15 and 20 ampere receptacles located within 20ft (6.0m) of the pool shall be protected by a ground fault circuit interrupter (GFCI).
The 20ft (6m) distance is measured via the shortest straight line distance the supply cord would follow without piercing a floor, wall, ceiling, doorway, window, or
other permanent barrier.
4. Contact your local utilities, checking that no underground cables, telephone lines, gas lines, etc. run beneath the area you have selected.

Setup Instructions

1. Locate a level and flat area to setup the pool. Make sure the ground is free from sharp objects as it may puncture the pool.
2. LIFT the pool liner across the ground. DO NOT drag the liner from one location to another location.
Inflate the Pool
To inflate pool, squeeze the base of the valve stem to open an internal check valve while inflating. Do not over inflate or use high-pressure to inflate this product.
NOTE: This pool has a maximum water fill level marked on the inside wall. Do not overfill, drain to proper level.
Emptying and Deflating Pool
Deflate pool, and/or push down on side wall and/or lift up one side of pool to empty pool water.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
8 8
SETUP INSTRUCTIONS
1
MST. Extended operating days and hours during peak season requirements.
2 3