Skoda DMM 630 001 Manual De Montaje página 18

- insert the preparation with the spacer into the hole in the riveted nut and screw the
spacer in.
- release the self-locking nut and uncsrew the screw.
Fastening points for fitting the trunk grille in the ceiling panel between the C-pillar and
the D-pillar of the vehicle (Fig. 6 - 12)
GB
- Position the template (J) for marking the hole into the ceiling panel between the
C-pillar and the D-pillar of the vehicle carefully according to the description on the tem-
plate itself.
- Mark the spots for future holes.
- Stab the upholstery pins into the marked spots which allows you to check the position of
future holes (whether they are under the holes in the roof side bearer).
- Check the spacing of the holes by measuring.
- Remove the upholstery pins and drill holes of 26 mm diameter into the ceiling panel (use
preparation MTX 9-193/B).
- Rivet the riveting nuts (B) with washer (C) into the holes of the roof side bearer under the
roof panel, using the riveting preparation MTX 9-193/A. Proceed in the same way as with
riveting the nuts into the holes of the body under the lining of the luggage compartment.
See the procedure as described above.
- Srew the spacers (D) on using the screw M8 x 50 and the self-locking nut M8 and tighten
these properly. Proceed in the same manner as with screwing the spacers (E). See the pro-
cedure as described above.
- Screw the plastic-head screws (H) into the spacers and by measuring re-check the spac-
ing of the holes for fitting the trunk grille. If the spacing of the holes is correct, unscrew the
screws and fit caps (F) on the spacers. If the spacing of the holes does not conform, apply
slight pressure on the screwed-in screw or adjust the distance accordingly.
- When mounting the caps (F) be careful not to deform the panel of the ceiling. If the ceiling
panel appears to be uneven at the caps, pull it out and straighten it using the upholstery pin.
Adjust the caps so that their wider part pointed towards the window (i.e. the offset on the
cap must be directed to the interior of the vehicle).
Fastening of the trunk grille (Fig. 13 - 14)
- Insert he trunk grille into the trunk of the vehicle and adjust it to the prepared fastening
points. Fasten it using the plastic-head screws (G, H). Tighten the screwsb by hand to the
endstop.
Tilt the back-seat rests back to the standard position.
Mount the trunk cover back into the vehicle according to the instructions in the manual Trunk
grille - fitting (removal) of trunk cover DMM 630 012. Pass the fitting (removal) instructions of
the trunk cover on the customer.