Stobag MOVENO DSRC-E Instrucciones Para La Instalación Y El Uso página 35

4) Programming
The programming phase is divided into 3 parts:
1. Memorisation of the transmitters
2. Programming of positions "0" and "1"
3. Optional programming
The memorisation phases must be performed as indicated in table A1 to ensure that a transmitter can control a MOVENO DSRC-E motor.
WARNING:
• All the memorization sequences are timed, that is, they must be completed within the programmed time limits.
• For transmitters with multiple "groups", choose the transmitter group the motor must be associated with before proceeding with the
memorization phase.
• Programming via radio may be done on all the receivers within the range of the transmitter; therefore, only the one involved in the operation
should be kept switched on.
It is possible to check if the motor already has transmitters memo-
rized; this is done by checking the number of beeps when the motor
is switched on.
4.1) Programming the transmitters
Table "A1" Memorizing the first transmitter (in Mode I)
1. Connect the motor to the power supply, 2 long beeps will be heard immediately
Within 5 seconds press and hold button ■ of the transmitter to be memorized
2.
(for approx. 3 seconds).
Release button ■ when you hear the first of the 3 beeps confirming memorization
3.
See table A2 for the memorization of additional transmitters
When one or more transmitters have already been memorized, others may be enabled as shown in table A2.
Table "A2" Memorizing additional transmitters (Mode I)
Press and hold down button ■ of the new transmitter (for approx. 5 seconds)
1.
until you hear a beep then release it.
Press button ■ of a previously memorized transmitter slowly 3 times.
2.
Press button ■ on the new transmitter again. Release button ■ when you hear the
3.
first of 3 beeps, signalling that memorization has been carried out.
Note: If the memory is full (14 transmitters), 6 beeps will indicate that the transmitter cannot be memorized.
Table "A2 -1" Memorizing a sensor (Mode I)
1. Press and hold down button P1 of the new sensor (for approx. 5 seconds)
until you hear a beep then release it.
Press button ■ of a previously memorized transmitter slowly 3 times.
2.
3. Press button P1 on the new sensor again. Release button P1 when you hear the
first of 3 beeps, signalling that memorization has been carried out.
Note: If the memory is full (14 transmitters), 6 beeps will indicate that the transmitter cannot be memorized.
"P1"
www.stobag.com
Control of the memorized transmitters
2 long beeps No memorized transmitter
2 short beeps There are already transmitters memorized
Example
Example
New 5s
Old X3
New
Example
5s
Old X3
GB
3s
35