Memory Deletion; Additional Information - Stobag MOVENO DSRC-E Instrucciones Para La Instalación Y El Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
4.3.5) Modifying position "1"
Follow the procedure indicated in table "A10" to modify position "1":
Table "A10"
Modifying position "1"
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds).
Press and hold buttons ■ ▼ for another 5 seconds until 2 rapid beeps are heard.
2.
At this point the awning automatically moves to the position "1".
Use buttons ▼ and ▲ within 5 seconds to reposition the awning in the new position
3.
to be programmed.
Confirm the position by pressing buttons ■ ▼ of the transmitter together within
4.
5 seconds until 3 beeps are heard and a short up and down movement is performed.
Note: if the programming described in point 4 is not confirmed the modifications are aborted and the previous programming is maintained.
By modifying position "1" the „FRT" functions are cancelled.

4.4) Memory deletion

If you need to delete all the transmitter and the programmed operations, carry out the procedure shown in table A11.
The memory can be deleted:
• with a non-memorized transmitter starting from point A.
• with a previously memorized transmitter starting from point No. 1.
The following can be deleted:
• only the memorized transmitters, finishing at point No. 4
• all data (transmitters, sensor level, TTBUS address, etc.), completing the procedure until point 6.
Table "A11"
Memory deletion
A.
Switch the motor off, activate the Step-by-Step input (by connecting the White cable
with the White/Black one) and keep it active until the end of the procedure.
B.
Power the motor and wait for the initial beeps.
Press and hold down button ■ on a transmitter (about 5 seconds) until you hear
1.
a beep; then release it.
Hold down the ▲ button on the transmitter until you hear 3 beeps;
2.
release the ▲ button exactly during the third beep.
Hold down button ■ on the transmitter until you hear 3 beeps;
3.
release button ■ exactly during the third beep.
Hold down the ▼ button on the transmitter until you hear 3 beeps;
4.
release the ▼ button exactly during the third beep.
5.
To cancel everything:
Press both ▲ and ▼ within 2 seconds.
Cancellation is confirmed by releasing buttons ▲ and ▼ on the first of the 5 beeps.
6.

5) Additional information

The MOVENO DSRC-E motors recognise other SKIMY and SKIROSOL series transmitters (see chapter 5.1 "Available transmitters").
Warning: use transmitters that have been memorised in Mode 1 only for programming.
5.1) Available transmitters
Table A12 indicates the transmitters that can be used with the related
coding.
Table "A12"
Transmitters
SKIMY SRCH
SKIMY SRCW
SKIMY SRCU (the whole series)
SKIROSOL SRCK 610 / 620 / 630
38
SKIMY SRCH
SKIMY SRCW
Example
5s
5s
Example
PP
5s
SKIMY SRCU
SKIROSOL 610
SKIROSOL 620
SKIROSOL 630
www.stobag.com

Publicidad

Tabla de contenido
loading

Tabla de contenido