Andis WDS-1 Instrucciones De Uso Y Cuidado página 5

shaver will turn on. After the battery is fully charged, the charging indicator
light will turn green.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance
you know is working).
2. Check to make sure adapter cord is plugged firmly into shaver. Twist
the adapter connector slightly to insure good electrical connection.
If failure to charge still exists while product is under warranty, return shaver
to Andis for examination and/or replacement.
WET/DRY OPERATION
This product is IPX5 certified for use with water. Product can be easily used
in the shower and with water or gels.
FOR SHAVING
For longer hair, use the long-hair trimmer feature before shaving for a
more effective result.
1. Remove the protective plastic headguard.
2. Check to make sure the outer foils and inner cutters are not damaged.
3. Ensure that the battery is charged.
4. Slide the ON/OFF switch up to the ON position.
5. Gently stretch the skin with your free hand while moving the shaver
slowly and smoothly against the grain of your hair. Hold the shaver at a
90 degree angle to your skin while maintaining contact with the foil.
6. In order to achieve the closest shave and avoid unnecessary wear on the
foils, be sure that both foils contact the skin simultaneously at all
times. Holding the shaver at an angle where only one foil contacts the
skin will cause distortion of the foil and may result in skin irritation.
7. To facilitate cutting and avoid foil wear, use minimal pressure to apply the
shaver to your skin.
8. To maximize shaving comfort, be sure to clean the shaver thoroughly
after use.
USING THE BIKINI COMB ATTACHMENT
1. Place back end of comb onto back of shaver, then press down to snap
into place.
2. Hold the shaver at a right angle to your skin and press down gently.
3. Edge and shape the area as desired.
4. After shaving, turn the shaver OFF.
5