Kohler K-3341 Guia De Instalacion página 6

Ocultar thumbs Ver también para K-3341:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Install the Sink (cont.)
Ensure there are no gaps between the sink rim and the
countertop.
Allow the sealant to cure for at least 30 minutes before
proceeding.
Connect and tighten the trap to the strainer, and complete the
water supply connections to the faucet according to the
instructions packed with the faucet.
Run water into the sink and check for leaks.
Clean up with a non-abrasive cleaner.
Undercounter Installation
WARNING: Risk of personal injury. Metal surfaces are sharp
and can cause severe cuts. Use gloves and handle sink edges
carefully.
CAUTION: Risk of product damage. Do not cut, drill, or sand
the countertop while it is positioned over the fixture.
Cut out the opening by carefully following the pencil line traced
from the template.
For Wood Countertops
Mark and pre-drill the wood screw holes at the locations shown
on the template.
Waterproof any exposed areas of wood.
For Marble/Stone Countertops
Position the countertop upside down on foam padding to protect
the surface. Mark and drill 3/8" holes 5/8" (1.6 cm) deep at the
locations shown on the template.
Use a setting tool and hammer to secure the anchors.
For All Installations
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation
instructions.
Install the faucet to the countertop according to the faucet
manufacturer's instructions.
Install the strainer to the sink according to the strainer
manufacturer's instructions.
NOTE: Do not use adhesives or adhesive sealants.
1019945-2-B
6
Kohler Co.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-14302

Tabla de contenido