MONITOR DESCRIPTION
F
unction push buttons.
Push button ring tone selection monitor, (for description see page 44).
Push button for intercom function (only available on systems with additional monitor,
for description and connection see page 44 y 45).
Regardless of the handset position, d
autoswitch-on processes
During activation, the picture will disappear from the monitor screen.
It allows to visualize the video and the audio from the door panel during 40 seconds.
With the handset off the cradle, it allows to establish audio and video communication
with the door panel. In case of systems with two door panels, press the button again
to monitor the picture from the second door panel.
During call reception, communication and autoswitch-on processes, it allows lock release
activation. During activation, the picture will disappear from the monitor screen.
C
all volume control.
The monitor allows to regulate the volume of call with the switch of
three positions placed in the right side of the monitor.
Maximum: For a high volume, place the switch in the top position.
.
Medium: For a medium volume, place the switch in the medium position.
Mute: Without volume, place the switch in the low position. If the monitor ring tone is
C
onfiguration switches
The configuration switches are placed on the monitor base.
Master
On installation with one monitor only, set it as master; when
Slave
On installations with two monitors, set as slave the monitor that is not connected
IMPORTANT: On installations with two monitors, set as master the monitor where the door
, activate the auxiliary device (see page 46).
muted and a call is made on the door panel, the picture will appears on the
monitor; to establish audio communication pick up the handset.
.
installations with two monitors, set as master the monitor where the door panel
is connected and the other monitor as slave.
the door panel.
panel is connected.
uring call reception, communication and
41
SLAVE