Important Safety Notes; Safety Precautions; Installation Precautions; Cleaning The Device - Urmet 1092/708 Manual De Usuario

IMPORTANT SAFETY NOTES

Power supply
This device must be powered exclusively by 230Vca mains voltage.

SAFETY PRECAUTIONS

Avoid introducing any object or liquid into the device. If this should accidentally occur, disconnect
the device from the mains and have it inspected by qualified personnel.
For any repairing, contact skilled staff or our authorized technical service.
Do not touch this device with wet hands, in order to avoid electric hazard.

INSTALLATION PRECAUTIONS

Wait for a while before operating a device immediately after transporting it from a cold place to a
warm place and vice versa. Wait on average for three hours: this will allow the device to adapt to
the new ambient (temperature, humidity, etc.).
Do not use this device in smoky, steamy, damp or dusty environments.
Before starting the device, remove the plastic protection intended to protect the power supply
inside.

CLEANING THE DEVICE

Rub delicately with a dry cloth to remove dust and dirt.
Dip the cloth in neutral detergent if dirt cannot be eliminated with a dry cloth alone.
Do not use volatile liquids (such as petrol, alcohol, solvents, etc.) or chemically treated clothes to
clean the device to prevent deformation, deterioration or scratches to the surface finish.
POSITIONING AND CONNECTION WITHOUT USING THE REF.1092/709 ALARM
CARD
After the place where to install the camera is found, follow the instructions below:
Make the fixing holes according to the wall type (cement or wood) and prepare the fixing
devices (screw anchors, screws, etc.)
Fix the connection Power Box to the surface.
Open the Power Box by unscrewing the four screws on the cover corners.
Insert in the wire grommets all the cables needed for the correct operation of the camera. For
outdoor installations, pay attention to close hermetically the wire grommets, in order to maintain
the IP protection grade.
RJ45 CONNECTOR
Connect the dedicated terminal pins to the mains by removing the protection cover, that must
be positioned back again after making the connections, but do not power the Power Box until
the installation has been completed.
For analog cameras, connect the video cable from the video device in use (DVR, monitor, etc.)
to the female BNC connector placed inside the box, taking care to put the rubber sheath for the
protection of the metallic parts, in order to avoid that these ones make electrical contact with
internal electronic parts. For IP cameras, use the RJ45 connector instead.
DS1092-228
BNC CONNECTOR
9