Skil PS4561C-00 Manual Del Propietário página 15

4. Carefully pour the bar and chain oil into the tank. Be careful not to let the oil spill from the
opening. Do not overfill and leave approx. 13/64 in (5 mm) space between the oil level and
the inside edge of the tank to allow for expansion. Wipe off any excess oil.
5. Replace and fasten the cap.
NOTICE:
We recommend using environment-friendly biodegradable chain oil specifically intended to
•
be used with pole saws.
Never use oil or other lubricants not specifically designed for use on the bar and chain. This
•
can lead to a clogged oil system, which may cause premature wear of the bar and chain.
Check the oil level frequently and fill when the oil level falls below the minimum line. Never
•
operate the pole saw if the oil is not visible.
Do not use dirty, used or otherwise contaminated oil. Damage may occur to the bar or chain.
•
It is normal for oil to seep from the saw when it is not in use. To prevent seepage, empty the
•
oil tank after each use, and then run the saw for one minute. When storing the tool for a long
period of time, be sure the chain is lightly lubricated; this will prevent rust on the chain and
bar sprocket.
To preserve natural resources, please recycle or dispose of oil properly. Consult your local
•
waste authority for information regarding available recycling and disposal options.
To Attach/Detach Battery Pack
WARNING
when the tool is not in use, or when carrying it at your side. Removing the battery pack
will prevent accidental starting that could cause serious personal injury.
To attach the battery pack (Fig .6):
1. Align the ribs of the battery pack with the
mounting slots in the pole saw's battery
port.
2. Slide the battery pack into the tool until it
snaps into position.
NOTICE:
Make sure that the latch on the pole
saw snaps into place and the battery pack is
secured to the tool before beginning operation.
Battery tools are always in operating condition. Therefore, remove
the battery when assembling parts, making adjustments, cleaning,
Fig.6
15