Skil PS4561C-00 Manual Del Propietário página 16

To detach the battery pack (Fig .7):
WARNING
children, or pets when pressing the battery-
release button. Serious injury could result if
the battery pack falls. NEVER remove the
battery pack at a high location.
1. Hold the battery pack in the palm of your
hand.
2. Press the battery-release button with your
thumb; the battery pack will disengage from
the latch.
3. Grasp the battery pack and remove it from
the pole saw.
Starting/Stopping the Pole Saw
Before Starting the Pole Saw:
DANGER
THE BAR, CHAIN OR THE ALUMINUM POLE! THEY CAN BECOME ELECTRICALLY LIVE
AND MAY BE VERY DANGEROUS. Continue to hold the pole saw by the insulated rear
handle or lay it down and away from you in a safe manner. Disconnect the electrical
service to the damaged line or cord before attempting to free the bar and chain from
Contact with the bar, chain, other conductive parts of the pole saw, or live
the line or cord.
electric cords or lines will result in death by electrocution or serious injury.
WARNING
recommended can result in serious personal injury.
Before each use, inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced.
1. Remove the battery pack.
2. Make sure that the chain is properly mounted and correctly tensioned.
3. Check the tension of the side-cover knob before use. If it is loose, securely tighten the
side-cover knob.
4. Check the oil level and fill the tank as needed. Make sure the chain is well lubricated.
5. Check the sharpness of the cutting teeth of the saw chain.
6. Hold the pole saw with both hands: with the right hand on the rear handle and the left hand
on the assist handle.
7. Make sure that you have a secure and balanced footing. Watch out for obstacles such as
tree stumps, roots, and ditches, which could cause you to trip or stumble.
8. Make sure the saw chain is not touching the ground or any other objects.
9. Make sure that cutting object does not exceed the usable cutting length of the pole saw.
The tip of guide bar shall always be kept at least 2" (50mm) outside the outline of the wood
log.
16
Always be aware for the
location of your feet,
Never cut near power lines, electric cords, or other electric sources. If
the bar and chain jams on any electrical cord or line, DO NOT TOUCH
Do not use any attachments or accessories not recommended by the
manufacturer of this product.
Fig.7
The use of attachments or accessories not
2
1