Technical Data; Noise Information; Vibration Information - Ratio TR750NM Manual De Instrucciones

TECHNICAL DATA

Type TR750NM(PDI-designation of machinery, representative of Impact Drill)
Rated voltage
Rated power
Rated no load speed
Impact rate
Chuck capacity max
Drilling capacity
Protection class
Weight

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
KPA & KWA
Wear ear protection.

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 60745
Impact drilling into concrete:
Drilling into metal:
The declared vibration total value may be used for comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used dependant on
the following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions of
use should also take account of all parts of the operating cycle such as the times when
the tool is switched off and when it is running idle but not actually doing the job. This may
26
Steel
Masonry
Wood
Vibration emission value a
Uncertainty K = 1,5m/s²
Vibration emission value a
Uncertainty K = 1,5m/s²
= 6.66m/s
2
h,ID
= 2.62m/s
2
h,D
230 – 240V ~ 50Hz
750W
0-3000/min
0- 48000/min
13mm
13mm
16mm
30mm
/II
1.9kg
LpA : 92dB(A)
LwA : 103dB(A)
3.0dB(A)