PALSON 30595 Modo De Empleo página 16

GB
Side brush replacement (4)
Study the following diagram to ensure correct replacement.
1. Remove the screws as shown in Fig. 1.
2. As per Fig. 2, rotate the side brush (4) until you can insert a screwdriver, the loosen the screw,
remove the used brush and replace it with a new one.
3. Assemble the brush and bottom cover in reverse order.
intelligent guidance
The robotic vacuum is intelligently controlled for efficient operation and to avoid obstacles, as well as
to prevent it from falling over, off a table or down stairs.
NOTE: Before using the robotic vacuum, remove any small objects such as containers, small paper
bins, etc. from its path that are likely to fall over during cleaning.
Take the following points into consideration:
1. If the system is running but switches off after the tone sounds, the battery may be low and the
device needs charging.
2. Do not use the robotic vacuum on thick rugs.
3. Avoid using the robotic vacuum in places where clothing, cables, towels, etc. are likely to become
tangled in its brushes.
16