Melchioni Family NEW MIKA Manual De Usuario página 9

PARTS INTRODUCING
SETOUT BEFORE USING
a. Install truckle
Take out four truckles, two wheel brackets.
According to picture A, Firmly install truckle on wheel bracket.
b. Install wheel bracket
Take out two wheel-bracket of the above installed truckle, take two normal screws of 4mm from accessories.
According to picture B, firmly install wheel-bracket on the bottom of product's front and back panel.
WALLMOUNTING USING
a. Drill holes into the wall
As picture D shows, electrically drill four Φ 8mm, 35 mm deep holes in proper place on the wall.
b. Install plastic setscrews
As picture D shows, use a Mini hammer to make setscrews into the holes which's finished in prior step.
c. Install woodscrews
As picture D shows, Use a screwdriver to make both Φ4mm, 35mm long wood screws into the prepared
setscrews.
d. As Picture E shows, choose the right installation size.
e. Mount the heater
As picture F shows, make sure the two holes at the back of panel aim at the woodscrews on the wall, mount
the heater then move 10mm to the down.