About This Handbook; Safety Instructions; Scope Of Supply - AL-KO CLASSIC 3.2E Instrucciones De Uso

GB

About this handbook

Read through these operating instructions before
starting up the machine. This is a prerequisite for
safe and trouble-free working
You should save these instructions, and also pass
them on to any subsequent users

Safety instructions

Caution!
Disconnect the machine from the mains power
supply before commencing assembly and main-
tenance work!
The machine must not be operated before assem-
bly work has been completed
The machine may only be operated in perfect tech-
nical condition
Protective guards and other safety equipment must
not be disabled

Scope of supply

1x operating instructions
1x assembly instructions
1x upper bar
2x lower bar
1x grass catcher, upper part
1x grass catcher, lower part
1x baffl e
2x front wheel / wheel cap Ø 125 or 150
2x rear wheel / wheel cap Ø 150 or 180
1x bag of screws
1x cable holder
1x cable strain relief
Assembly
See illustrations in the assembly instructions.
Assembly of baffl e (
1. Insert the bearing rod of the baffl e.
2. Pull left-hand / right-hand springs forward until they
engage.
3. Secure the baffl e holder with a Ø 4,2x15 screw.
10
1)
Assembly of lower bar in housing (
1. Insert lower bar into the recesses as far as the stop
and secure on each side with a Ø 4,8x16 screw.
Assembly of upper bar on lower bar (
1. Push on cable strain relief.
2. Fasten upper bar to lower bar with screw and
wing nut.
Assembly of bearing components on upper bar
( 4, a-b)
1. Push on cable fi xing clamp.
2. Mount switch/connector combination
with 2 screws Ø 4x25.
Assembly of wheels (
1. Push wheel onto axle until it clicks into place.
2. Insert axle at desired cutting height.
3. Holding onto the fi rst wheel, push on the second
wheel. This wheel must also click into place.
Assembly of grass catcher (
1. Push the upper part onto the pins of the lower part
of the grass catcher (
2. Close both parts of the grass catcher together and
secure with 2 Ø 4,2x15 screws (
Attaching the grass catcher (
1. Lift the baffl e.
2. Lift the grass catcher and attach it in place.
3. Press the baffl e.
Handling
Adjusting the cutting height (
1. With the button pressed, pull off the wheel.
2. Pull out the axle and reinsert at the desired
cutting height.
3. Push wheel back on until it clicks into place.
4. Adjust the second axle in the same way.
Translation of original user instructions
Electric lawnmower
2)
3, a-c)
5, a-c)
6-7)
6).
7).
8)
9, a-b)