ABL Wallbox eMH3 Instrucciones De Uso página 25

NOTE
Authorisation of the RFID card is refused
If the RFID card is rejected, the blue LED of the RFID module is ON for two seconds and then turns OFF.
ƒ Master/Slave with backend: Make sure that your RFID card has been registered with your
backend operator. Contact your backend operator for further information.
ƒ Slave without Master and with active RFID module: Make sure that the RFID card has been
registered at the RFID module. You can find further information in the comprehensive installation
manual.
9
Check the LED indicators of the wallbox
(illustration: 1 cycle).
y The green LED is continuously ON while
the wallbox waits for the charging proce-
dure to be initiated by the electric vehicle.
y When the charging procedure begins
following a request by the vehicle, the
green LED flashes.
y When the charging procedure is paused
or completed, the green LED is again
continuously ON.
NOTE
Interruption or completion of the charging procedure
The charging procedure may be paused by the vehicle. Otherwise, the charging procedure is automati-
cally terminated by the vehicle upon completion.
ƒ Check the displays inside the vehicle: Should the vehicle not be fully charged upon completion of
the charging procedure, you may need to have it checked.
10
Unplug the charging connector from the elec-
tric vehicle's charging inlet and close it.
Wallbox eMH3 – Charging procedure | 25