Commissioning - Schneider Airsystems MLH Kfz Manual De Instrucciones Original

GB
MLH
NOTICE
Sparks can cause fires.
Some material machining methods gen-
erate sparks that can cause fires or
smouldering!
Avoid spark formation!
Make sure the unit is used for the
intended purpose!
NOTICE
No-load impacts will cause the chisel
hammer and retaining cap / Phillips re-
taining cap to wear prematurely.
Avoid no-load impacts!
Make sure the unit is used for the
intended purpose!
• Protect yourself and other persons, ani-
mals, property, and the environment by
taking the necessary protective measures
and being trained in use of the devices to
prevent harm to your health, property
damage, financial
harm or risk of accident.
• Be calm and focused and ensure proper
operation.
• Repairs may be carried out only by
Schneider Druckluft GmbH or its approved
service partners.
• Prohibited: manipulation, inappropriate
use, temporary repairs, use of other ener-
gy sources, removal or use of damaged
safety equipment, operating a leaking or
malfunctioning system, use of non-original
spare parts, exceeding the permitted
working pressure specified (max. + 10%),
working without protective equipment,
transporting / maintaining / repairing or
leaving a pressurised machine unattended,
using other / unsuitable lubricants, smok-
ing, naked flames, removing stickers.
• Prohibited: Touching the chisel during op-
eration.
II/ 8
loss, environmental
2.4

Commissioning

Before start-up:
1. Observe technical data, figures, item
numbers, intended use and safety in-
structions
(see Instruction manual, Part 1, Chap-
ter: "Technical data" and the "Intended
use" chapter).
2. Carry out a visual inspection.
3. Do not use below 5° C.
If necessary
attach the chisel according to the ma-
chine type:
Chisel assembly:
1. Unscrew the
(item 05) from the device.
2. Insert a suitable chisel with hexagonal
bolt through the support on the Phillips
retaining cap (item 05) (Fig. 2a).
or:
1. Insert the relevant chisel into the retain-
ing cap (item 06).
2. Pull the ends of the buffer ring (item 10
) apart and clamp around the chisel
(Fig. 3a).
3. Insert the relevant chisel with retaining
cap (item 06) into the hexagon adapter
on the cylinder (item 04).
4. Screw the retaining cap (item 06) onto
the thread of the cylinder (item 04) up to
the stop and tighten.
Before using the tool, check that the
chisel, retaining cap / Phillips retain-
ing cap are seated securely.
Compressed air connection:
1. Install an upstream maintenance unit
with filter pressure reducer and mist oil-
er.
2. Press the quick-action coupling of the air
hose onto the plug nipple (item 01)
(Figure 1a).
Phillips retaining cap