Troubleshooting - Schneider Airsystems MLH Kfz Manual De Instrucciones Original

GB
MLH
2.9

Troubleshooting

Observe the safety instructions and maintenance instructions!
Problem
A Chisel hammer does
not operate cor-
rectly
B Phillips retaining
cap (item 05)
comes off during
operation
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
II/ 10
Cause
Air regulation setting (item 03)
too low.
Chisel worn
Working pressure (flow pres-
sure) too low
Compressor output too small
Hose diameter too small
Deflector valve worn.
O-ring (item 11) on the cylin-
der (item 04) worn or missing
(Fig. 2b)
Remedy
Adjust to a higher setting.
Replace chisel***
Increase working pressure (flow
pressure) Observe
working pressure
Use different output
*
rating
Use correct hose diameter
Contact Schneider
GmbH or an authorised service
****
partner.
***
Replace O-ring.
maximum
*
*
Druckluft