English; Switch Settings - Braun creation C 1900 DF Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 7

English

Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy your new Braun
appliance.
Carefully read the use instructions before use.
Important
• Plug your hairdryer into an alternating current (Ù)
outlet only and be sure that your household
voltage corresponds to the voltage marked on
the hairdryer.
• This appliance is not intended for use by children
or persons with reduced physical or mental
capabilities, unless they are given supervision by
a person responsible for their safety. In general,
we recommend that you keep the appliance out
of reach of children.
This appliance must never be used near
water (e.g. a filled wash basin, bathtub or
shower). Do not allow the appliance to
become wet.
• When using the hairdryer in a bathroom, always
unplug it after use. Even a switched-off hairdryer
presents a hazard if not unplugged.
• For additional protection, it is advisable to install
a residual current device (RCD) with a rated
residual operating current not exceeding 30 mA
in the electrical circuit of your bathroom. Ask
your installer for advice.
• Care should be taken not to block the inlet and
outlet grill when the hairdryer is switched on.
If either grill becomes blocked, the hairdryer will
automatically cut out. After cooling for a few
minutes, it will switch back on automatically.
• Do not wrap the mains cord around the
appliance. Regularly check the mains cord for
wear or damage, particularly where it enters the
product and the plug. If you have any doubt
about its condition take the appliance to your
nearest Braun Service Centre for checking/
repair. The mains cord of the appliance may only
be replaced by an authorised Braun Service
Centre. Unqualified repair work can lead to
extreme hazards for the user.
Description
1
Switch
2
Cold shot button
3
Protection filter
4
Concentrator nozzle
5
Diffusor attachment
1

Switch settings

C 1700
0
off
2
gentle drying
3
fast drying
1
styling
2
Cold shot
To fix a style with cold air, press the cold shot button.
3
Protection filter
Regularly wipe the filter clean. For a thorough
cleaning, remove the filter and clean it under
running water.
Concentrator nozzle
For precise styling use the concentrator nozzle.
Diffusor attachment
Attaching the diffusor (a)
• Align the notches on the rim of the diffusor
attachment with the slots in the hair dryer.
• Push the attachment onto the hairdryer, then
turn clockwise until the bayonet lock clicks
into place.
• To remove the diffusor, turn in the opposite
direction and pull.
Volume styling
• Short to mid-length hair:
To add volume and root lift, gently guide the
diffusor fingers with a small circular motion
over your scalp. Continue section by section.
• Long hair:
First dry hair ends by placing them onto the
finger plate. Then, with the diffusor, carefully lift
the hair to your head and hold. Finish off the
roots with a gentle circular movement of the
diffusor fingers on the scalp to add some lift.
Subject to change without notice.
This product conforms to the European
Directives EMC 2004/108/EC and Low
Voltage 2006/95/EC.
Please do not dispose of the product in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or at appropriate collection points
provided in your country.
C 1900
0
1
1-2
2
3
1
3
4
5
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Creation c 1700 df

Tabla de contenido