Installation; Preparing For Installation - Glacier bay HD834X-0001 Guía De Instalación Y Cuidado

Installation

1

Preparing for installation

CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply to the tub and
shower.
□
Verify that the hole sizes and positions of the
holes in the wall are correct
□
The shower and tub spout outlet holes
should be 1-1/4 in. diameter.
□
For the cold water inlet (the right side)
and the hot water inlet (the left side),
cut or leave a 1-3/8 in. diameter hole
(recommended size is 1-3/4 in.). The
center to center distance between the
cold and hot water inlets is 8 in.
48 in.
Tub & Shower
30 in.
Shower Only
8 in. Min.
48 in.
Shower Only
30 in.
Tub & Shower
NOTE: Do not disassemble the cartridges and diverter
during normal installation. When reinstalling the cartridges,
be sure to insert them with the limit stop (a & b) pointed
inward as shown in the diagram. When reinstalling the
diverter, be sure to insert the face (c) with the markings
"UP" facing upward as shown in the diagram.This is
necessary for proper operation of the valve.
c
1-3/8 in. ~ 2 in.
1-3/8 in. ~ 2 in. 1-3/8 in. ~ 2 in.
8 in.
a
2
Installing the supply
connections
NOTE: Be sure to position the valve body (D) correctly in
the wall, with the markings "UP" facing upward. Hot water
supply lines go into the "H" inlet; cold water supply lines
go into the "C" inlet.
□
Wrap thread sealant tape around the valve body
(D) threads in a clockwise direction, as shown.
□
Thread the waterline (1) to the valve body (D),
and tighten with a wrench.
Hot
b
7
Please contact 1-855-HD-GLACIER for further assistance.
D
HOMEDEPOT.COM/GLACIERBAY
1
Cold