Publicidad
Idiomas disponibles
Idiomas disponibles
May we congratulate you on your new Botanica
GB
Dear Customer!
The assembly of your new house requires a bit of
technical knowledge. However, it is important that the
assembly instructions are followed strict-ly. The assembly
instruction is a combination of text and illustrations.
The profiles are packed in separate numbered packs
corresponding to the order in the assembly instruction.
Erect one pack at a time. All nuts and bolts and fittings are
found in bag No. 0 (specified on page 12). Each pack is
specified in separate lists of components.
All detailed illustrations are marked with symbols:
seen from inside
seen from outside.
Precautions.
•
Assembly must only be carried out in
dry and calm weather.
•
Always use working gloves while
glazing. Greenhouse glass has sharp
edges, especially if the glass breaks.
•
Assistants and especially children
must be warned that broken glass is
an element of danger. Pick up broken
glass at once and remove it with care.
•
We recommend to use protective
glasses while fixing the spring wire
clips.
•
Place the ladder on a level support.
•
It is essential to have an assistant.
References
The column marked
indicates the page(s) on
which the component is used.
Page 13:
Foundation
The base is not included in this delivery. However, an
original base can be bought separately. It ensures you a
stable and easy to build base.
If you make your own base the measurements indicated
must be external measurements.
If you buy an original base you furthermore need about
75 litres of concrete and 6 plastic-/concrete pipes of about
800 mm which are placed in a non-freezing depth for the
fastening of the corner and middle anchors.
The base must be 100% level and square; the latter is
ensured by checking that the two diagonal measurements
are equal.
Tools
The mounting of the greenhouse requires the tools shown
on page 12.
Page 15-25:
Place the components as shown on the illustration
and assemble in the order shown in the pictures. Do
not tighten the nuts completely until the front gable
construction has been assembled.
Page 13:
(Fastening to the base).
When constructing your own base you have to drill holes
(7 mm) in the ground frame between all the vertical
frames, the greenhouse is then fastened to the base with
screws (A).
Using an original base the greenhouse is fastened to each
vertical bar as shown on drawing B.
Page 21-24:
For an easier assembly we recommend that you oil the
screws for the doors /windows.
Fitting of glass/polycarbonate
Important before glazing!
Make sure that gables and sides are level
and square, and that door(s) and window(s)
are functioning perfectly.
Best order of assembly:
1) Windows – 2) Roof – 3) Doors – 4) Gables – 5) Sides
Page 26-27:
Glazing (illustration 1 to 8)
Degrease the sheets and frames with acetone.
Start glazing from below, one glass at a time. Apply a 3
mm silicone line on the vertical frames where indicated
(dotted lines on the illustration). (A 3 mm line of silicone is
sufficient to obtain maximum attachment). If you do use
more than recommended, you can buy extra tubes.
In case of broken glass carefully pull it outwards and
loosen the silicone by means of a sharp craft knife.
Clean the profile completely before inserting a new pane
of glass.
3
Now your greenhouse is completely assembled. However,
please notice the following:
Maintenance
•
Grease doors (hinges and lock or doortrack).
•
Clean the gutter for leaves, etc.
•
Adjustment of windows.
•
Replacement of broken glass.
•
Clean the house with disinfectant before and after
the growing season.
Winter Protection
In areas with occurrence of snow we recommend the
following winter protection:
•
Support the roof ridge at the centre of the house.
•
Remove greater snow loads from the roof.
•
Take precautions against snow falling down from for
instance a tree or a roof.
•
Dismount the cylinders for the automatic window
openers, if any (optional extras).
•
Secure door(s) and window(s) preventing wind
damage to the house.
Insurance
Please note that not all insurance companies cover
glasshouses automatically. Please contact your insurance
company to ensure an insurance coverage.
Guarantee
Botanica grants a guarantee of 12 years which covers
replacement of faulty parts. The guarantee does not cover
polycarbonate, glass, transport, assembly, freight etc.
Botanica grants a guarantee of 2 years on painted parts,
if any. Note that marks in the painting may occur due to
suspension of the profiles.
The guarantee is invalid if the greenhouse is not
assembled according to these instructions.
Complaints
All our greenhouses are built to high standards of quality.
However, should a complaint occur please contact
your dealer at once. Remember to specify the defect
by indicating the greenhouse model and number of the
component and the color of the greenhouse.
USA
Publicidad
