Before First Use; Requirements For The Set-Up Location; Wall Mounting - Nevadent SMD 24 A1 Manual Del Usuario

Before first use

Requirements for the set-up location

To ensure safe and trouble-free operation of the appliance, the set-up location must fulfil
the following requirements:
► The appliance may only be operated free-standing if used in dry rooms. The set-up
location must be a horizontal, level and stable surface.
► In damp rooms, especially in the vicinity of water, the appliance must be firmly fixed
to the wall to protect it from falling into water.
► The mains power socket must be easily accessible so that the power cable can be
quickly disconnected in an emergency.

Wall mounting

NOTE
► Before mounting to the wall, make sure that there are no electric cables, wires or
pipes running behind the wall surface where you plan to hang the appliance.
1. Mark two drill holes on the wall 7.2 cm apart and drill the marked holes with a 5 mm
bit. Ensure that there is a power socket in the immediate vicinity.
2. Push the two supplied wall plugs
8
screws into the wall plugs
3 mm out of the holes.
3. On the back side of the appliance, the right hanger
the appliance from coming free of the screws
until you hear a click. Then pull the locking pin
(see Fig. 1).
1.
Fig. 1
SMD 24 A1
9
into the drilled holes and screw the two supplied
9
. Take care that the screws
2.
8
still protrude about
6
has a locking pin
8
. Press the locking pin
7
down slightly out of the hanger
7
to prevent
7
back somewhat
6
GB │ MT │
47 ■