Axxess BACKUPCAM-3 Instrucciones De Instalación

GM Vehicles
AxxessInterfaces.com
Visit for more detailed information about the product and up-to-date vehicle specific applications
INTRODUCTION
The BACKUPCAM-3 is designed to retain the factory backup camera to be viewed
through the display screen on the aftermarket radio, or a stand-alone monitor.
COMPONENTS
• 12-pin harness with a yellow RCA jack
APPLICATIONS
CHEVROLET
Colorado (†) 2015-up
Cruze (†) 2016-2018
Cruze Hatchback (†) 2016-2018
Equinox (†) 2018
Impala 2014-up
Malibu (†) 2016-2018
Silverado 1500-LD (†) 2019
Silverado 1500 (†) 2014-2018
Silverado 2500/3500 (†) 2015-up
Suburban 2015-up
Tahoe 2015-up
(†) With RPO code I05 or I06 radio
Note: The vehicle must be running for the factory camera to power on.
Integrate • AxxessInterfaces.com
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
BACKUPCAM-3
INSTALLATION INSTRUCTIONS
2014-up
GMC
Canyon (†) 2015-2017
Sierra 1500-Limited (†) 2019
Sierra 1500 (†) 2014-2018
Sierra 2500/3500 (†) 2015-up
Yukon 2015-up
Yukon XL 2015-up
REV. 11/21/18
Connections to be made
From the 12-pin harness with a Yellow RCA jack
To the aftermarket radio:
• Connect the Yellow RCA jack to the BACKUP CAMERA
input.
To the vehicle:
• Connect the female 12-pin harness with a Yellow
RCA jack, to the male Gray harness removed from
the Human Machine Interface module. (Figura A)
For the Chevy Colorado and GMC Canyon:
• This module is located in the radio cavity, down low.
For all other models:
• This module is located behind the glove box. There
are (2) modules behind the glove box. This module is
behind the metal dashboard support. (Figura B)
• Drop the glove box down by first removing the
retaining cable on the right side. Then squeeze
the glove box sides and gently pull down.
• Remove (6) T-15 Torx screws securing the plastic
panel now exposed.
K P
® NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
Integrate • AxxessInterfaces.com
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
BACKUPCAM-3
INSTALLATION INSTRUCTIONS
Human Machine Interface module
(Figura A)
(Arrow points to the location)
(Figura B)
If you are having difficulties with the installation of this product,
contact our Tech Support line either by phone at 1-800-253-TECH,
or email at techsupport@metra-autosound.com. Before doing
so, look over the instruction booklet a second time and ensure
that the installation was performed exactly as the instruction
booklet is stated. Have the vehicle apart and ready to perform
troubleshooting steps before contacting Metra/Axxess Tech Support.
REV. 11/21/18