Using The Tectalk Easy - Albrecht Tectalk Easy 2 Manual Del Usuario

4

Using the Tectalk Easy 2

4.1 Turning the Device On/Off
To turn the devices on or off, hold down the Power-button for 3
seconds a BEEP sound will be played to confirm.
4.2 Adjusting the Volume
To increase the volume, press the ▲- button and press the ▼-
button to decrease the volume.
Note: The volume level is displayed on the screen.
4.3 Battery Level Indication
The battery level is shown by a number of squares present
inside the battery icon on the LCD screen. When the batteries
are low, the battery icon flashes and the unit beeps to indicate
that the batteries need to be replaced respectively the NiMH
cells need charging.
4.4 Receiption
The radio is continuously in the receive mode when the unit is
on and not transmitting. When you receive a signal on the
current channel, the RX icon is displayed on the LCD.
4.5 Transmitting
Don't transmit if someone is already talking on the channel.
•
Press and hold the PTT/Call-button to transmit. The TX
Indicator will be shown on the LCD.
•
Hold the unit in a vertical position with the microphone
about 5 -7 cm away from the mouth and speak in
normal loudness.
It is important, that you and all your partner stations have
selected the same operating channel.
Note: This device is equipped with an automatic TX time
limitation (TOT). After 180 seconds of continious transmission,
the radios will return to RX mode. To transmit again, the
PTT/Call-button needs to be released and pressed anew.
English 17