Residual Risks - Battipav VIP Manual De Instrucciones

GB

RESIDUAL RISKS

During the design phase, BATTIPAV SRL paid
particular CAUTION to the aspects that may generate
risks for the safety and health of operators.
In spite of this, there are still some potential risks,
which are described below:
CAUTION
• Danger of presence of electric current.
The machine has an internal electric system:
CONNECT THE MACHINE TO A SYSTEM WITH
DIFFERENTIAL PROTECTION AND EFFECTIVE
EARTH WIRE.
CAUTION
• Danger of prolonged exposure to noise:
The continuative use of the machine causes an
exposure to noise levels above 85 dB (A).
OPERATORS MUST
DEFENDERS.
CAUTION
• Danger of exposure
materials. OPERATORS
PROTECTIVE GOGGLES.
CAUTION
• Danger of accidental contact with the moving
tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE
GLOVES
ALWAYS STAY IN THE WORKING POSITION
(Pos. 1 picture 10) DURING THE MACHINE
OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the
machine stop.
22
USE PROPER EAR
to fragments
MUST WEAR
MAINTENANCE
CAUTION
BEFORE PERFORMING ANY OPERATION OR
ADJUSTMENT, DISCONNECT THE MACHINE FROM
THE SUPPLY MAINS.
CLEANING
CAUTION
DO NOT WASH THE MACHINE WITH HIGH
PRESSURE WATER JETS
It is extremely easy to clean the VIP machine by
15
loosening the side knobs and dismantling the
working table.
Through the side tap remove any working
residual.
When necessary clean the sprayer as
16 17
shown.
of
CAUTION
MOTOR CARRIAGE ADJUSTMENT
18
The motor carriage is provided with a register for
the vertical play adjustment.
If any excessive play of the motor carriage
should take place, act as follows:
1) Loosen the register fi xing nut with a 10 mm
wrench;
2) Screw down the dowel with a 3 mm Allen key until
the play is eliminated.
3) Lock the register again with the fi xing nut.
Battipav srl