Installation; Connecting The Power Supply; Installing The Boundary Wire - GreenWorks Optimow 4 Manual Del Operario

Installation

0cm

CONNECTING THE POWER SUPPLY

Connect the power supply in a cool, dry environment; out of direct
sunlight.
If the power supply is connected to an electrical socket outdoors, it
must be approved for outdoor use.
The low voltage cable can cross the operating area if it is stapled down
or buried.
CAUTION: Do not cut, splice, or alter the low voltage cable. Altering
product gurantee.

INSTALLING THE BOUNDARY WIRE

Lay down the loop wire reel at the charging station.
Go back around the boundary of the operating area and secure the
boundary wire either using pegs or buried in the ground. Pegs are
recommended since this allows for adjustment during the first few
weeks of operation.
When securing the boundary wire with pegs:
• Cut the grass very low with a standard lawnmower or a trimmer
where the wire is to be laid.
•
Lay the boundary wire on the ground and secure with pegs
close together.
•
Push or hammer the pegs into the ground.
Do not push the pegs so far into the ground so that they strain the
boundary wire.
When burying the boundary wire:
• Bury the boundary wire 1—20 cm into the ground.
EN
3
GREENWORKSTOOLS.EU
Version 1 - 7 .2