Descargar Imprimir esta página

Guinaz A2420 Guia De Instalacion página 19

Videoporteros

Publicidad

MANTENIMIENTO.
El grupo A2420 lleva instalado un led rojo cuya funcionalidad es la siguiente:
Group A2420 comes with a red LED with the following functions:
The LED is off: Group A2420 is idle.
The LED is on without blinking: Group A2420 is active, that is to say, there is a call in progress.
The LED blinks at 1 second intervals: It is a main panel with a secondary panel that is active.
The LED blinks 4 times a second: Installation error. There is more than one A2420 group configured as
the main one or there are none configured as the main one.
SOLUCIÓN DE PROBLEMAS.
PROBLEMA
PROBLEM
No funciona nada.
Nothing works.
No aparece la imagen en el
monitor.
No image appears on the
monitor.
All manuals and user guides at all-guides.com
MAINTENANCE.
PROBLEM SOLVING.
POSIBLE FALLO
POSSIBLE FAULT
±
Check the voltages between terminal blocks 1-2 (12 VAC) and between
11-5F (16VDC±1VDC) in the power supplies. If there are problems with
any of these outputs, disconnect the PRIM cables, wait for one minute
and reconnect them. Should the problem persist, check the installation
connections.
Check connection cables 11-5 (16VDC± 1VDC) in the monitor. There
should be 12 VDC between terminal blocks 14 and 5F of the camera
module when the monitor is switched on. The video signal cable (coaxial
or twisted pair) must be connected correctly. Verify there is a connector
between the audio module and the camera module in the street panel.
In the case of there being video distributors in the installation, check
they have correct power supply.
±

Publicidad

loading

Este manual también es adecuado para:

M1710dM1730dM2710dM1740dM2740d