Publicidad
COLOCACIÓN DE LOS TARJETEROS.
1
Extract the name card unit
from the push-button
module of the street
panel.
INSTALACIÓN DE FUENTE DE ALIMENTACIÓN.
INSTALLATION OF POWER SUPPLY.
The power supply can be installed on a DIN slide or by means of sleeper-screws into the wall, always internally.
All manuals and user guides at all-guides.com
2
3
Separate
translucent
glass part.
The street panel is sufficiently protected
against atmospheric conditions. However, it
is recommendable to install it in a place where
agents such as rain, humidity, etc. cannot
affect it.
When the panel is exposed to the elements
it is recommendable to install it with a visor
frame. In the case of surfaces that are not
smooth, where the street panel or visor frame
are not perfectly sealed with the joints that
are incorporated, then some sort of sealer
should be applied throughout the entire upper
part of the street panel or visor frame to thus
avoid water from penetrating and damaging
the equipment.
PLACEMENT OF NAME TAGS.
4
Insert the card.
push-button module
until it clips in.
When choosing the location to install a
video door entry system it is important
to find a location where the source of
light (sun, street lamps, etc.) does not
directly affect the camera, to thus avoid
the effect of the back light on the image.
If the image is not clear and sharp due
to a lack of light for the camera, then
auxiliary lighting should be placed as is
duly indicated in the figure. This auxiliary
lighting can be installed in such a way
that it only lights up the scene when a
monitor is working.
Insert in the
Publicidad
