Service Parts - NuTone QTXEN Serie Guia De Instalacion

CONNECT WIRING
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.

SERVICE PARTS

Key No. Part No.
1 97016466 Housing
2 97016450 Duct Connector-6"
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97018010 Wire Panel/Harness Assembly
6 97017782 Blower Assembly (QTXEN050)
97020047 Blower Assembly (QTXEN080)
97020048 Blower Assembly (QTXEN110)
7 99140199 Grille Spring (2 req'd)
8 97017622 Grille Assembly (includes key no. 7)
9 97018014 Spacer (2 supplied)
10 QTNHB1 Hanger Bar Kit
11 99420665 Thumbscrew, #8-18 x .375
Order service parts by "Part No." - not by "Key No."
SERVICE NOTE To remove Blower Assembly: Unplug motor.
Remove thumbscrew (11) from motor plate flange. Find the
single TAB on the motor plate (located next to the recepta-
cle). Push up near motor plate tab while pushing out on side
of housing. Or insert a straight-blade screwdriver into slot in
housing (next to tab) and twist screwdriver.
Description
MODELS QTXEN050 • QTXEN080 • QTXEN110
INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach grille
to housing.
Squeeze grille
springs and insert
them into slots on
each side of hous-
ing.
7. Push grille
against
ceiling.
Page 4
Replacement parts can
be ordered on our web-
site. Please visit us at
www.nutone.com
99045487A