NuTone QTRN Serie Guia De Inicio Rapido
Ocultar thumbs Ver también para QTRN Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

QTRN SERIES
FAN / LIGHT / NIGHT LIGHTS
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address
or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
4. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code authori-
ties.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Acceptable for use over a tub or shower when connected to
a GFCI (Ground Fault Circuit Interrupter) - protected branch
circuit.
8. This unit must be grounded.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazard-
ous or explosive materials and vapors.
2. This product is designed for installation in ceilings up to a
7/12 pitch. Duct connector must point up. DO NOT MOUNT
THIS PRODUCT IN A WALL.
3. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power
unit.
4. Please read specification label on product for further informa-
tion and requirements.
Installer: Leave this manual with the homeowner.
To register this product visit:
www.nutone.com
CLEANING & MAINTENANCE
For quiet and efficient operation, long life, and attractive appear-
ance - lower or remove grille and vacuum interior of unit with the
dusting brush attachment.
The motor is permanently lubricated and never needs oiling. If the
motor bearings are making excessive or unusual noises, replace
the blower assembly (includes motor and impeller).
OPERATION
The fan, light, and night light can be operated separately. Use a
3-function wall control. See "Connect Wiring" for details.
WARRANTY
NuTone warrants to the original consumer purchaser of its products that
such products will be free from defects in materials or workmanship for
a period of three years from the date of original purchase. THERE ARE
NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT
NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE.
During this three-year period, NuTone will, at its option, repair or replace,
without charge, any product or part which is found to be defective under
normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP
STARTERS AND TUBES. This warranty does not cover (a) normal main-
tenance and service or (b) any products or parts which have been subject
to misuse, negligence, accident, improper maintenance or repair (other
than by NuTone), faulty installation or installation contrary to recommended
installation instructions.
The duration of an implied warranty is limited to the three-year period as
specified for the express warranty. Some states do not allow limitation
on how long an implied warranty lasts, so the above limitation may not
apply to you.
NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE'S OP-
TION, SHALL BE THE PURCHASER'S SOLE AND EXCLUSIVE REMEDY
UNDER THIS WARRANTY. NUTONE SHALL NOT BE LIABLE FOR INCI-
DENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF
OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some
states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other
rights, which vary from state to state. This warranty supersedes all prior
warranties.
To qualify for warranty service, you must (a) notify NuTone at the address
or telephone number stated below, (b) give the model number and part
identification and (c) describe the nature of any defect in the product or
part. At the time of requesting warranty service, you must present evidence
of the original purchase date.
Broan-NuTone LLC Hartford, Wisconsin
www.nutone.com 888-336-3948
MODELS QTRN080L • QTRN110L
NUTONE THREE YEAR LIMITED WARRANTY
Page 1

Publicidad

Tabla de contenido
loading

Resumen de contenidos para NuTone QTRN Serie

  • Página 1 MODELS QTRN080L • QTRN110L Page 1 To register this product visit: QTRN SERIES www.nutone.com FAN / LIGHT / NIGHT LIGHTS READ AND SAVE THESE INSTRUCTIONS CLEANING & MAINTENANCE WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN- For quiet and efficient operation, long life, and attractive appear-...
  • Página 2: Typical Installations

    MODELS QTRN080L • QTRN110L Page 2 TYPICAL INSTALLATIONS PLAN THE INSTALLATION COOKING AREA Do not install above or inside this area. NOT FOR USE IN Cooking A COOKING AREA. Equipment Floor Housing mounted to I-joists. Use I-joist spacer block (provided). INSULATION (Can be placed ROOF...
  • Página 3 MODELS QTRN080L • QTRN110L Page 3 INSTALL HOUSING & DUCT CONNECT WIRING 1. Bend housing tabs. Use a pliers to bend housing TABS out to 90 TABS 2. Mount SPACER housing to (use for mounting to I-Joist) joist. Hold housing in place so that the housing tabs contact the bottom of the joist. The hous- ing mounts with I-JOIST four (4) screws or nails. Screw or nail housing to joist through lowest holes in each mount- ing flange, then through highest holes. NOTE: Mounting to I-JOIST (shown) requires use of SPACERS (included) 5.
  • Página 4: Service Parts

    Duct Connector-4” (next to tab) and twist screwdriver. 98010102 Wiring Plate 99170245 Screw, #8-18 X .375 97018011 Wire Panel/Harness Assembly 97016621 Blower Assembly (QTRN080L) 97018218 Blower Assembly (QTRN110L) 97016543 Grille Assembly (includes key nos. 8 & 9) 99140199 Grille Spring (2 req’d) 99111281 Lens 97018014 Spacer (2 supplied) 99420665 Thumbscrew, #8-18 x .375 Order service parts by “Part No.” - not by “Key No.” Replacement parts can be ordered on our web- site. Please visit us at www.nutone.com 99044598A...
  • Página 5: Ventilador/Lámpara/Lámparas De Noche Serie Qtrn

    La duración de una garantía implícita se limita al período de tres años como se 8. Esta unidad debe conectarse a tierra. especifica para la garantía explícita. Algunos estados no permiten la limitación de la duración de una garantía implícita, de manera que las limitaciones antedichas podrían no aplicarse a usted. PRECAUCIÓN LA OBLIGACIÓN DE NUTONE DE REPARAR O REEMPLAZAR, A OPCIÓN DE NUTONE, SERÁ EL ÚNICO Y EXCLUSIVO RECURSO DEL COMPRADOR BAJO ESTA GARANTÍA. NUTONE NO SERÁ RESPONSABLE 1. Sólo para usarse como medio de ventilación general. No se use para POR DAÑOS INCIDENTALES, RESULTANTES O ESPECIALES QUE SURJAN DE O EN RELACIÓN CON EL USO O RENDIMIENTO DEL PRODUCTO. descargar materiales ni vapores peligrosos o explosivos. Algunos estados no permiten la exclusión o la limitación de daños incidentales 2. Este producto se diseña para la instalación en techos hasta una echada o resultantes, de manera que es posible que la limitación antedicha no se de 7/12. Conector de conductor debe señalar hacia arriba. NO MONTE...
  • Página 6: Instalaciones Típicas

    MODELOS QTRN080L • QTRN110L Página 6 INSTALACIONES TÍPICAS PLANIFICACIÓN DE LA INSTALACIÓN ÁREA QUE COCINA No instale sobre o dentro de esta área. NO PARA EL USO EN UN Equipo ÁREA QUE COCINA. para cocinar Montaje de la cubierta en viguetas “I” . Piso Utilice un taco separador de viguetas “I”...
  • Página 7: Instale La Cubierta

    MODELOS QTRN080L • QTRN110L Página 7 CONEXIÓN ELÉCTRICA INSTALE LA CUBIERTA Y EL CONDUCTO 1. Doble las lengüetas de la cubierta. Con un alicate, doble las LENGÜE- LENGÜETAS TAS de la cubierta a 90°. 2. Monte la SEPARADOR (se usa cubierta en para el montaje a la vigueta “I”) la vigueta. Sostenga la cubi- erta en su lugar de manera que las lengüetas de la cubierta hagan contacto con la...
  • Página 8: Piezas De Repuesto

    Conjunto del ventilador (QTRN080L) cubierta (junto 97018218 Conjunto del ventilador (QTRN110L) a la lengüeta) 97016543 Conjunto de la rejilla (incluyen las y haga girar el piezas de las claves n. 8 y 9) destornillador. 99140199 Resorte de la rejilla (se requieren 2) 99111281 Lente 97018014 Separador (provisto 2) 99420665 Tornillo de mariposa n. 8-18 x 0.375 Al hacer el pedido de una pieza de servicio se debe especificar el número de la pieza (no el número de la clave). Las piezas de recambio se pueden ahora pedir en nuestro Web site. Visítenos por favor en www.nutone.com 99044598A...

Este manual también es adecuado para:

Qtrn080lQtrn110l

Tabla de contenido