NuTone QTXN Serie Guia De Instalacion página 3

Ocultar thumbs Ver también para QTXN Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONNECT WIRING
HEAT
&
NIGHT LIGHT
RED to BLACK
(Heat)
BLACK to YELLOW
(Night Light)
WHITE to WHITE
WIRING PLATE
GROUND
FROM VENTILATOR
WHITE
to
WHITE
CAUTION
RATING SPECIFICATIONS
• The three-position
rocker switch is rated 5 A
@ 125VAC. Use this switch
for Lights ONLY.
• Each two-position rocker
switch is rated 15 A @ 120VAC. Use these switches for Heat and Vent.
• The total load on this control must not exceed 20 A @ 120VAC.
5. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connectors to secure house wiring to
wiring plate. Connect wires as shown in wiring diagram(s).
INSTALL GRILLE & BULBS
6. Finish ceiling.
Install ceiling material. Cut out ceiling material closely
around housing.
7. Remove
light lens
from grille.
Insert a small
flat-bladed screw-
driver into the slot
at one end of the
light lens. Care-
fully pry the lens
out.
LIGHT
&
FAN
VENTILATOR
HOUSING
RED to RED
(Fan)
BLACK to BLUE
(Light)
WHITE to WHITE with red stripe
BLACK to RED
BLACK to BLUE
4-FUNCTION CONTROL
120 VAC LINE IN
(purchase separately)
BLACK to BLACKS
INSTALL GRILLE & BULBS
8. Plug-in
light.
Hold grille as-
sembly up near
housing. Connect
light plug from
grille assembly to
receptacle inside
of housing.
LIGHT (red)
NIGHT LIGHT (blue)
(3-position rocker)
FAN (2-position rocker)
9. Attach
HEAT (2-position rocker)
grille.
NuTone 4-Function
Remove the (2)
Control shown
grille mounting
screws from
the sides of the
housing. (See
Step 8 illustra-
tion.) Use these
screws to attach
the grille to
the housing as
shown.
To avoid damage to the grille: DO NOT OVERTIGHTEN
SCREWS. Tighten screws only until grille is snug against
ceiling material.
10. Install
bulbs.
The unit
accepts (2)
18-Watt 3500K
(maximum)
GU24 based
fluorescent
bulbs and (1)
7-Watt night
light bulb.
11. Attach
light lens.
Hook the tabs
on one end of
the lens into the
slot in the grille.
Lift other end
of lens up and
snap into place.
MODEL QTXN110HFLT
GRILLE MOUNTING
SCREWS
Page 

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Qtxn110hflt

Tabla de contenido