Installation - Marmitek DOORPHONE 120 Modo De Empleo

3. INSTALLATION

Before you get started with the installation, it is necessary that you fully charge the handset
(4-5 hours).
Charge handset:
A
S ee figure 1
1. Remove the battery cover by pressing on the battery cover lock (23).
2. Insert the additionally supplied battery pack into the battery compartment. Make sure you
connect the right polarities of the battery and the handset (22).
3. Place the battery cover back onto the handset. Beware! Do not put on the handset yet.
4. Insert the supplied power adapter into the connector at the back side of the docking station (28),
insert the electric plug into the power socket and place the handset into the docking station.
5. The red 'Charge' indicator light (25) and the green 'Full' battery indicator light (26) should
now go on and off alternately, which is to check the battery status. Shortly after that, only
the red charger indicator light (25) will keep flickering. During the charging, the battery
symbol shall be visible in the LCD screen and the segments shall start moving to
indicate that the handset is being charged.
6. After approximately 4 till 5 hours, the battery should be fully charged and the 'Full' battery
indicator light (26) shall burn constantly. When the battery is fully charged, the battery
symbol will disappear when the handset is off.
7. The handset is now ready for further installation. It is advisable that the handset be placed
in the docking station when not being used, so that it is always fully charged. This is not
damaging the battery.
Getting the set ready for installation:
The door unit needs to be set on the same channel as the handset. Check the settings and
adjust them if necessary, according to the instructions given below.
Note: - You always need to place 4 AA Penlite batteries into the door unit for start-up, even
when you will be using an external power supply (see 'Pairing procedure').
- In case you have more than one doorbell button on the door unit, then the channel
settings are predetermined at the factory and cannot be altered. In that case you can
skip the section 'Channel settings door unit'.
6
B C
Figure 1
D
© MARMITEK