EN
10
SAFETY INSTRUCTIONS
•
Read all instructions carefully.
•
Check the products rating label and make sure the water urn voltage is fit
for your outlet voltage before using.
•
The plug should be connected to the earth block.
•
Do not use the water boiler if the cord or plug is damaged.
•
If the water boiler malfunctions or is damaged, please call customer
services for checking and repairing.
•
Switch off the button before removing the plug.
•
Always switch off before trying to move the water boiler.
•
Grasp the plug when you remove it. Do not pull the cord.
•
Do not let the power cord hang over edge of a table.
•
Place the water boiler securely at the center of table.
•
Do not switch on the water boiler if the water tank is empty.
•
Do not place the water boiler near gas cooker, electric burner or heated
oven.
•
Power cord and plug can not touch water in the case of a leakage.
•
Please remove the plug from outlet, and cool off the plug before cleaning.
•
Press the Switch Off button, and remove the plug after using.
•
The appliance requires a 10-16 A plug.
•
The appliance is only to be installed in locations where it can be overseen
by trained personnel.
•
Do not remove the lid while boiling.
•
Position the lid so that steam is directed away from the handle.
•
Do not carry the urn while water inside.
•
If the appliance is overfilled, boiling water may be overspill.
•
The mash tun becomes hot when in operation! Always use heat-insulation
pot holders when gripping the handles.
•
Never dip the mash tun into water. Always protect the electric power
cable from misture.
Note: In some countries, it is required by law to register the production of
beer of self-use with the authorities.