oneConcept 10033079 Manual Del Usuario página 13

Hints on Operation
1. Always use the water urn on a flat level surface.
2. Do not fill the water urn with water above the maximum level indicator.
3. Connect the plug to the socket.
4. Switch ON and screw the knob to select the target temperature. The red
„heating" pilot lamp will light up and the water will start to heat up.
5. Once the boiling temperature has been reached the red heating light will
go out and the green "keep warm" light will illuminate.
6. Stand your cup on the holder close to the tap to prevent the splashing of
hot water.
7. Use the tap to dispense water.
8. When the water is topped up the water urn will automatically re-boil.
9. When about three cups of water are remaining in the tank, turn the
appliance off and unplug it from the electric outlet.
10. Always make sure at least three cups of water are remaining in the tank to
prevent a boil-dry accident.
11. The urns can be very heavy when filled with water. Urns should not be
carried or moved when full of water as the weight and unsteady load can
cause injury or strain. Urns should be placed in their position of use and
filled by using a portable hose or several trips with a smaller, manageable
container (such as a jug). To ensure operator safety in lifting the machines,
urns should never be moved when filled with more than 5 litres (5 litres =
approximately 5Kg).
TROUBLESHOOTING
Problem
No power after turning on
the power switch
Pilot lamp not working
Keep-warm fail
Possible causes
Switch has burnt out
Dry burn before adding
water and the thermostat
overload has been cut off
Bulb has burnt out
Connected incorrectly
Adjustable thermostat
malfunction
What to do
Replace with a new switch
Wait for the sparger to
cool down to below 115 °C
Replace with a new bulb
Reconnect correctly
Repair with a new
adjustable thermostat
EN
13