Practical Tips For Use; Cleaning And Maintenance - essentiel b EBM10 Manual De Utilización

You can also adjust the operating speed of the unit during mixing:
9.
- Set the "ON/OFF" knob to the "ON" position and then turn the knob to a position
between the "MIN" mark (low speed) and the "MAX" mark (high speed).
- [TAB]Choose the most suitable speed for the ingredients used. The unit will operate at
the selected speed until you return the on/off button to the "OFF" position.
WARNING!
If the motor overheats, the unit automatically stops to prevent damage to the motor. Wait
about 10 minutes until the unit cools down, unplug it and plug it in again: the appliance can
be used again.
When your preparation is ready, turn the on/off button to the "OFF" position and unplug
10.
the plug from the power point.
Remove the jar from its base.
11.
Remove the lid. You can now serve the preparation.
12.

Practical tips for use

Cut meat or solid food into pieces before putting them in the blender.
•
If you need to mix/chop large amounts of solid food, do so in small portions.
•
Some preparations cannot be properly made in a blender:
•
- Whisked egg whites
- Whipped cream
- Mashed potatoes
- Minced raw meat
- Kneaded dough
- Fruit and vegetable juice extraction
Liquids or other ingredients can be added at any time without stopping the machine.
•
Remove the measuring cap from the lid (by turning it anticlockwise). Do not exceed the
maximum recommended quantities.
26
V.1.0
use

cleaning and maintenance

WARNING!
Before cleaning your blender, make sure that the "ON/OFF" button is in the "OFF" position
•
and that the unit is unplugged from the power point.
Never immerse the motor unit, power cord, plug or jar in water or any other liquid.
•
There is a potential risk of injury if used incorrectly.
•
Never place the appliance and accessories in the dishwasher!
•
The blades are sharp. It is essential that you take special precautions when handling them
•
to avoid injury.
Never use scouring pads or abrasive detergents for cleaning.
•
DISMANTLING THE APPLIANCE
Lift the blender jar off its base and place it on a fl at, stable surface.
1.
Remove the measuring cap by turning it anticlockwise.
2.
Turn the lid anticlockwise and remove the lid.
3.
Make sure the blender jar is empty, turn it over and place it on a fl at and stable surface.
4.
Unscrew the 4-blade knife assembly by
5.
turning it clockwise to the "OPEN" position.
Remove the blade gasket from the plastic base.
6.
27
V.1.0
cleaning and maintenance