essentiel b EBM10 Manual De Utilización página 15

Warning!
During reassembly, pay close attention to which way up the gasket is on the base: smooth
side towards the base and ribbed side towards the glass of the jar.
GENERAL CLEANING RECOMMENDATIONS
Immediately rinse all the parts after use for easy cleaning.
•
Wipe the motor unit with a sponge, and then thoroughly dry it with a soft cloth.
•
Stubborn stains can be removed with a damp sponge and possibly a little non-abrasive
•
detergent (washing up liquid, for example).
The removable parts (lid, measuring cap, blender jar) should be washed by hand with water
•
and washing up liquid. No removable parts can be placed in the dishwasher.
Be sure to clean the lid seal and the 4-blade knife gasket thoroughly. When they are clean
•
and dry, put them back on the unit properly.
The blender jar should not be immersed in water or any other liquid. To clean the jar, see the
•
"Cleaning and maintenance - Cleaning the jar" section.
QUICK CLEANING OF THE JAR
To quickly rinse the jar (in between preparations, for example), you can use clean water and run the
appliance for a few seconds. In this case, do not use detergent.
THOROUGH CLEANING OF THE JAR
To thoroughly clean the jar, pour some warm water in the jar and add a few drops of washing
•
up liquid.
Use a brush to remove all traces of soup or food and rinse.
•
Add 800 ml of clean water to the jar with a small amount of washing up liquid, close the
•
lid and run the unit for a few seconds in normal or "PULSE" mode (see the "Use" section).
The blades will rotate to clean the jar, and you can stop the cleaning process at any time by
turning the knob to the "OFF" position.
Rinse the jar again with clean water.
•
Then thoroughly wipe with a soft, dry cloth. Make sure the jar is completely dry before
•
placing it back on the motor unit.
CLEANING THE LID
Pour some warm water into the lid and add a few drops of washing up liquid.
•
Use a brush to remove all traces of soup or food and rinse.
•
Then thoroughly wipe with a soft, dry cloth. Make sure the lid is completely dry before
•
placing it back on the jar.
You can also clean the seal. To do this, remove it, taking care not to damage it. Clean the
•
28
V.1.0
cleaning and maintenance
seal with a damp sponge and possibly a little non-abrasive detergent (washing up liquid, for
example). Once dry, return it to its original position: when the lid is fi tted on the blender, the
two lips point downwards.
MOTOR UNIT
Clean any stains on the motor block with a clean, slightly damp cloth and dry it completely.
•
STORAGE
Wrap the power cord around the cord holder located under the motor unit and store the
•
appliance in a cool, dry place.
29
V.1.0
cleaning and maintenance