Tabla de contenido
Publicidad
Enlaces rápidos
Publicidad
Tabla de contenido
Manuales relacionados para Fisher-Price PLATINUM CLICK
Resumen de contenidos para Fisher-Price PLATINUM CLICK
- Página 1 GHP42 OWNER’S MANUAL...
-
Página 2: Tabla De Contenido
TABLE OF CONTENTS BEFORE YOU BEGIN ..........3 PARTS .................4 CHECK THE LOCATION FOR THE GATE ....5 SIZE THE GATE ............8 ASSEMBLE THE GATE ..........9 GATE CLAMP INSTALLATION .........13 GATE FASTENER INSTALLATION ......17 GATE STAIRWAY INSTALLATION ......24 REMOTE FASTENER INSTALLATION ....29 REMOTE ADHESIVE INSTALLATION ....32 INSTALL BATTERIES ..........34 OPERATING THE GATE ...........35... -
Página 3: Before You Begin
BEFORE YOU BEGIN Keep this instruction sheet for future reference, as it contains important information. Discontinue the use of the gate if it becomes damaged, broken, or disassembled. Adult assembly and setup is required to mount the gate and remote, and install batteries. Tools required for hardware installation: Electric drill, "(4,76 mm) drill bit, hammer and Phillips... -
Página 4: Parts
PARTS Gate 2 inch 4 inch 6 inch Extender Extender Extender Remote Remote Mount Clamps Gate Mounting Gate Bracket Clamp Brackets Brackets Covers Tool x 10 M3.5 x 15 mm Screw M4 x 30 mm Screw 7,6 mm x 25,4 mm Wall Anchor... -
Página 5: Check The Location For The Gate
CHECK THE LOCATION FOR THE GATE Measure the width of the opening where the gate will be installed. The width of the opening should be no less than 30" (76,2 cm) and no greater than 42" (106,7 cm). The thickness of the If using clamps, wall/doorway/newel also measure the... - Página 6 CHECK THE LOCATION FOR THE GATE If attaching at the top of stairs, measure the distance from the first step to the gate. The distance from the first step to the gate should be at least two inches (5,1 cm) or more. 2 in If using fasteners When fastening to a stud...
- Página 7 It's assembly time! Continue reading or scan to watch a step-by-step assembly & installation video. fisher-price.com/assembly/GHP42...
-
Página 8: Size The Gate
SIZE THE GATE This gate fits in openings from 30" (76,2 cm) to 42" (106,7 cm). Use each gate extender alone or in combination. See below! Fits 30˝ - 31¼˝ 2˝ 4˝ 6˝ (76,2 cm - 79,4 cm) 5,1 cm 10,2 cm 15,2 cm opening... -
Página 9: Assemble The Gate
ASSEMBLE THE GATE If necessary, add extenders to fit the opening where the gate will be installed. Refer to page 8 for sizing. Fit the post on the end of the mounting bracket into the slot in the side of the gate. - Página 10 ASSEMBLE THE GATE Rotate the mounting bracket down to fit to the side of the gate. M3.5 x 15 mm Screw...
- Página 11 ASSEMBLE THE GATE Fit the post on the end of the mounting bracket into the slot in the side of the gate. Rotate the mounting bracket down to fit to the side of the gate.
- Página 12 ASSEMBLE THE GATE M3.5 x 15 mm Screw If you are using clamps to install the gate, proceed to page 13. If you are using fasteners to install the gate, proceed to page 17. If you are installing near a stairway with a newel post, proceed to page 24.
-
Página 13: Gate Clamp Installation
GATE CLAMP INSTALLATION Fit the clamps to the gate brackets. Note: Make sure to fit the longer clamps onto the bottom end of the gate brackets. M3.5 x 15 mm Screw... - Página 14 GATE CLAMP INSTALLATION Fit the clamps to the doorway (or wall or newel post). Important: If installing in an opening with a door, make sure the button faces away from the door. Button Door Fit the clamps to the doorway (or wall or newel post).
- Página 15 GATE CLAMP INSTALLATION Using a level, check that both gate brackets are level. Using the clamp tool, tighten all four clamps so the gate brackets are secure to both sides of the doorway or newel posts.
- Página 16 GATE CLAMP INSTALLATION Slide the gate into the gate brackets. Check to be sure the gate is secure. Push the gate where indicated by the arrows. The gate should remain securely attached.
-
Página 17: Gate Fastener Installation
GATE FASTENER INSTALLATION M3.5 x 15 mm Screw Determine where you want to install the gate. Using a tape measure, measure the distance to the end of the wall. - Página 18 GATE FASTENER INSTALLATION Place the gate bracket against the wall with the bottom end on the floor. Using a level, check to be sure the gate bracket is level. Using a pencil, make three marks through the screw holes.
- Página 19 GATE FASTENER INSTALLATION Note: If you are attaching to a stud or into wood, you do not need to follow this step. Proceed to step 7. Using a 3/16" (4,76 mm) drill bit, drill one hole through each pencil mark you made on the wall.
- Página 20 GATE FASTENER INSTALLATION Insert a screw into each screw hole and tighten with a Phillips M4 x 30 mm Screw screwdriver. Do not over-tighten. Using a tape measure, make sure the distance to the end of the wall matches the measurement from the first gate bracket.
- Página 21 GATE FASTENER INSTALLATION Place the gate bracket against the wall with the bottom end on the floor. Using a level, check to be sure the gate bracket is level. Using a pencil, make three marks through the screw holes.
- Página 22 GATE FASTENER INSTALLATION Note: If you are attaching to a stud or into wood, you do not need to follow this step. Proceed to step 13. Using a 3/16" (4,76 mm) drill bit, drill one hole through each pencil mark you made on the wall.
- Página 23 GATE FASTENER INSTALLATION M4 x 30 mm Screw Slide the gate into the gate brackets. Check to be sure the gate is secure. Push the gate where indicated by the arrows. The gate should remain securely attached.
-
Página 24: Gate Stairway Installation
GATE STAIRWAY INSTALLATION If attaching at the top of stairs, measure the distance from the first step to the gate. The distance from the first step to the gate should be at least two inches (5,1 cm) or more. 2 in Using a level, check that the gate bracket is level. - Página 25 GATE STAIRWAY INSTALLATION Place the gate bracket to the wall and flat on the floor. Using a pencil, make three marks through the screw holes. Note: If you are attaching to a stud in a wall or into wood, you do not need to follow this step.
- Página 26 GATE STAIRWAY INSTALLATION Fit a wall anchor into each of the drilled holes. Tap each wall anchor lightly with a hammer until the ends of each wall anchor are even with the surface of the wall. M4 x 30 mm Screw...
- Página 27 GATE STAIRWAY INSTALLATION Fit the clamps to the newel post. Using the clamp tool, tighten both clamps so that the gate bracket is secure to the newel post.
- Página 28 GATE STAIRWAY INSTALLATION Slide the gate into the gate brackets. Check to be sure the gate is secure. Push the gate where indicated by the arrows. The gate should remain securely attached.
-
Página 29: Remote Fastener Installation
REMOTE FASTENER INSTALLATION The remote should be installed in a place most convenient to access from either side of the gate (e.g., door jamb). Place the remote mount to the door jamb. Using a pencil, make two marks through the screw holes. - Página 30 REMOTE FASTENER INSTALLATION Fit a wall anchor into each of the drilled holes. Tap each wall anchor lightly with a hammer until the ends of each wall anchor are even with the surface of the door jamb. Insert a screw into each screw hole and tighten with M4 x 30 mm Screw...
- Página 31 REMOTE FASTENER INSTALLATION Slide the remote down onto the mount.
-
Página 32: Remote Adhesive Installation
REMOTE ADHESIVE INSTALLATION Before applying adhesive strip, make sure the wall surface is clean and dry. If cleaning is necessary, gently wipe with isopropyl rubbing alcohol. Do not use household cleaners. Remove the liner from one side of the adhesive strip and apply sticky side to back of remote mount as shown. - Página 33 REMOTE ADHESIVE INSTALLATION Slide the remote down onto the mount. To remove the remote mount from the wall entirely: 1. NEVER pull mount towards you. 2. Hold mount gently to prevent it from snapping fingers. DO NOT press against wall. 3.
-
Página 34: Install Batteries
INSTALL BATTERIES Loosen the screws in the battery compartment doors. Use alkaline batteries for longer battery life. Insert two AA (LR6) alkaline batteries into the remote and three AA (LR6) alkaline batteries into the gate. Replace the battery compartment doors and tighten the screws. If the gate or remote do not seem to work or work erratically: Check to be sure the gate has power by activating the •... -
Página 35: Operating The Gate
OPEN THE GATE WITH REMOTE First, press the button in and the remote will illuminate red. While holding the button in, slide the button down to the bottom. The remote and gate will illuminate green. The gate is now unlocked. Once the gate is opened, both lights will illuminate red. - Página 36 OPEN THE GATE MANUALLY First, press the button in with your thumb. While holding the button in, slide the latch with your finger. The gate is now unlocked. Once the gate is opened, the gate will illuminate red. Once the gate is closed again, the light will turn off.
-
Página 37: Gate Closure Alert System
GATE CLOSURE ALERT SYSTEM If the gate remains open for more than 10 seconds, a closure alert will play 3 times, and the light(s) will illuminate red. If the gate remains open for an additional 50 seconds, the closure alert will play 10 times. -
Página 38: Temporary Gate Removal
TEMPORARY GATE REMOVAL Press the gate release button on one side, then slide the gate up and out of the bracket. While holding the gate, press the gate release button on the other side. Slide the gate up to completely remove it. - Página 39 GENERAL INFORMATION Always use this product where there is adequate ventilation. To prevent overheating, keep the product away from heat sources such as radiators, heat registers, direct sunlight, stoves, amplifiers, or other appliances which produce heat. FCC STATEMENT (UNITED STATES ONLY) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
- Página 40 If removable, rechargeable batteries are used, they are only to be charged under adult supervision. UNITED STATES Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052. Consumer Services: 1-800-432-5437. MÉXICO Importado y distribuido por Mattel de México, S.A. de C.V., Miguel de Cervantes Saavedra No.