Check Items Before Starting Recording; Standard Recording - JVC XM-R700SL Manual De Instrucciones

Check Items Before Starting Recording

• The MD is not the Play-only type one.
• The accidental erasure prevention knob of the MD cartridge is set to the close position.
• The MD has enough space for recording. If not, carry out ALL ERASE or ERASE function mentioned later to
erase all the tracks or desired tracks in the MD. You can check the recordable remaining time of the MD by re-
peatedly pressing the DISPLAY/CHARA. button on the unit in Standby mode. (See "Showing the Disc Informa-
tion" on page 7.)

Standard Recording

CAUTIONS:
• Be sure that the rechargeable battery is fully charged. Otherwise, the unit may shut off, leaving recording unfinished.
• While "UTOC Writing" appears on the display, to avoid improper recording, do not give a shock to the Unit and
do not disconnect any cable from the Unit, including the AC adaptor's cable.
Notes
• The recording operation is possible only with the buttons on the unit.
•
When a stereo signal is recorded in MONO mode, stereo sound will be heard though the signal is correctly recorded in
MONO mode.
1 Check the things before recording.
See "Check Items Before Starting Recording" above.
2 Insert an MD with its label side facing up.
Proceed to the next step after "TOC Reading" goes out on the display.
3 Slide the REC switch.
The unit enters Rec/Standby mode, the REC indicator lights up, and the disc mark blinks. The track number is
increased by one.
• To cancel Rec/Standby mode, press the 7/CHARGE button.
4 Within two minutes, press the REC MODE button to select the recording mode.
Each time you press the button, the display changes as follows:
SP = LP2 = LP4 = MONO
SP:
Signifies standard-hour stereo recording. The number of hours usable for recording is the same as
shown on the package of the MD.
LP2: Signifies 2 times long-hour stereo recording. The number of hours usable for recording is twice as
long as shown on the package of the MD.
LP4:
Signifies 4 times long-hour stereo recording. The number of hours usable for recording is 4 times as
long as shown on the package of the MD.
MONO: Signifies standard-hour monaural recording. The number of hours usable for recording is twice as
long as shown on the package of the MD.
5 Play the recording source.
6 Adjust the recording level for analog input only.
See "Adjusting the recording level" on page 10.
Press the 6 button to start recording.
7
When the MD becomes full, "UTOC Writing" appears on the display, indicating that the recording is success-
fully completed. The "TOC" indicator will light up during this period. Then, the MD stops. (The "TOC" indica-
tor goes out.)
To pause, press the 6 button. (The track number is increased by one.)
To cancel pause, press the 6 button again.
To stop recording, press the 7/CHARGE button. "UTOC Writing" appears on the display and then the MD stops.
(The "TOC" indicator goes out.)
Notes
• During recording, recording mode does not change even if the REC MODE button is pressed. To change it, you
need to stop the Unit.
• Once you have set the recording mode, it remains until the Unit is turned off. When the Unit is turned on, SP
(Stereo) recording mode is always selected.
9
(Appears only if MONO is selected.)
Total track number
Remaining time
Recording mode