Time Setting Mode - Terragene IC10FR Manual Del Usuario

Instructions for use
NOTE: 37 °C light indicates a.m. 60 °C light indicates p.m.
Complete time zone change
To save changes press and hold
(see next figure). A beep will sound indicating that process has been
completed successfully. A ticket with the new set time will be
printed.
Cancel time zone change
To cancel time zone change process without saving the
changes, disconnect power source.

Time setting mode

Time setting functionality allows you establish a specific time
regardless of auto-reader current time.
Modification of the time using the Bioupdate
Connect the auto-reader via the USB port to a PC and start-
up the program. Select the Bionova
and press the Clock Sync button, the auto-reader will be
synchronized with the PC's clock. Synchronization can only be
done as long as there is not an ongoing reading.
Change the time using the Bionova
Connect the auto-reader via the USB port to a PC and start-
up the program. The Bionova
synchronized with the PC's clock. Synchronization can only be
done as long as there is not an ongoing reading.
button for three seconds
Software
®
IC10/20FR Auto-reader
®
Traceability Software
®
IC10/20FR Auto-reader will be
®
IC10/20FR Page 11
Change the time using the panel
Enter Time setting mode
De-energize the auto-reader.
Press and hold both buttons and
and energize the equipment. A beep will be emitted to indicate
access to Time setting mode.
Hours setting
Lights corresponding to 1 to 10 incubation/reading positions
indicate the digit value which is set. Lights from 1 to 9 indicate
digit value from 1 to 9. Light 10 indicates 0 value.
In time setting mode, light 1 from PRO sector will turn on to
indicate ten hour modification and incubation light corresponding
to the 10th position will turn on to indicate setting started.
NOTE: 24-hour format.
To change hours and minutes digits, use
and buttons. To increase digit value press
; to decrease press
Increase
button simultaneously
(see next figure).
Decrease