Installing The Light Plate; Installing The Led Light Kit And Glass Shade - Kichler 60 Zenith Led Manual De Instrucciones

INSTALLING THE LIGHT PLATE

Step 1. Loosen the two screws on the mounting ring attached to the
motor shaft and "remove" and save the third screw. (Fig. 19)
Step 2. Place the key hole slots on the light plate over the two
screws previously loosened on the mounting ring.
Turn the light plate until is locks in place at the narrow section of the
key hole slots.
Tighten both key hole screws and replace the third screw previously
removed and tighten securely.
INSTALLING THE LED LIGHT KIT
AND GLASS SHADE
NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or
removing the fuse at fuse box.
Step 1. Loosen the three mounting screws on the inside of the LED light kit. (Fig. 20)
Step 2. While holding the LED light kit under the fan motor, make the wire connections: (Fig. 20)
- Red to white
- Black to black
Step 3. Tuck the connections neatly into the light plate. Place the key holes on the LED light kit
over the 2 screws previously loosened from the light plate, turn the LED light kit until it locks in
place at the narrow section of the key holes. Secure by tightening all three screws. (Fig.20)
Step 4. Raise the glass shade against the light kit and turn clockwise until snug, DO NOT
OVERTIGHTEN. (Fig. 20)
Mounting ring
Light plate
Screws
Fig. 19
Wire connectors
LED light kit
Light plate
Screws
Glass
shade
Fig. 20
60" ZENITH TM LED | 15