Attaching The Fan Blades; Installing The Light Plate - Kichler cULus 300285/85-GENT Serie Manual De Instrucciones

ATTACHING THE FAN BLADES

CAUTION: "To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing fan blade."
Step 1. Align the holes from the blade and blade support plate to
the holes from the blade arms, and secure the blade in place with
screws provided. (Fig. 15)
Step 2. Repeat this process to attach the other two blades.

INSTALLING THE LIGHT PLATE

Step 1. Loosen the two screws on the mounting ring attached to the
motor shaft and "remove" and save the third screw. (Fig. 16)
Step 2. Place the key hole slots on the light plate over the two screws
previously loosened on the mounting ring.
Turn the light plate until is locks in place at the narrow section of the key
hole slots.
Tighten both key hole screws and replace the third screw previously
removed and tighten securely.
Blade arms
Mounting ring
Light plate
Screws
60"/65"/85" GENTRY
Screws
Blade support
plates
Blades
Fig. 15
Fig. 16
15