Italtecnica Mito Instrucciones Para El Uso página 22

MOTOR
750W-6A max.
N '
L '
CONNECTION TO POWER SUPPLY
The power supply to the device is 230 Volt 50/60Hz single-phase. The electrical system to which the
device is connected must comply with the current safety regulations and must therefore be equipped
with:
- Automatic trip switch suitable for motor use and with a tripping current appropriate to the power of the
pump installed
- Earthing with total resistance in compliance with the local standards and in any case never greater than
1 0 0 Ω .
If the device is installed in swimming pools or fountains or garden ponds, it is compulsory that a type
" A " a u t o m a t i c d i f f e r e n t i a l s w i t c h ( R C D ) w i t h I ∆ n = 3 0 m A b e i n s t a l l e d .
If the device is not supplied with a fitted power supply cable and plug, install another device that
guarantees omnipolar disconnection from the power supply network with a contact gap of least 3 mm.
If the terminals supplied are not used, the faston terminals must be crimped, using specific pliers, by
specialized personnel.
The recommended diameter of the cables is 1.0mm
In the case of power supply line lengths greater than 5-10 meters, it is advisable to use a cable with an
appropriate larger diameter to reduce voltage drops in the cable.
The type of electric cable must be suitable for the conditions of use (use in domestic premises , dry or wet,
for indoor or outdoor installation).
2
, compatible with electric pumps up to 750W.
22
LINE
230V 50/60Hz
N
L