Programming; Interface Description; Description Of The Keys - Italtecnica Mito Instrucciones Para El Uso

 PROGRAMMING:
INTERFACE DESCRIPTION
1. Display, with digital indication of pressure,
errors and the configuration menu.
2. Keys for programming.
3. Power-on - Green indicator light (LINE).
4. Error - Red indicator light (FAILURE).
5. Pump on - Yellow indicator light (PUMP ON).
DESCRIPTION OF THE KEYS
Arrow/reset: Scrolls the pages of the menu forward and resets the unit in case of alarms and/or
errors
K e y " + " : I n c r e a s e s t h e v a l u e o f t h e p a r a m e t e r c u r r e n t l y s h o w n o n t h e d i s p l ay. Also permits
forced operation at maximum speed
K e y " -" : d e c r e a s e s t h e v a l u e o f t h e p a r a m e t e r c u r r e n t l y s h o w n o n t h e d i s p l a y .
DESCRIPTION OF THE PARAMETERS AND SCREENS
USER PARAMETERS:
These parameters are normally accessible when the device is powered.
off as Mito turns off the pump when water flow falls below the minimum value (approximately 4
litres/minute) regardless of the pressure reached in the system. Press the + and –keys to modify the
parameter value.
Main screen: When Mito is operating correctly, on the first line of the
display is shown the instantaneous pressure detected by the system; on the
second line a bar graph is displayed that reproduces the speed of the
p u m p ' s m o t o r.Wh e n t h e m e s s a g e " C o o l i n g ! " i s d i s p l a y e d o n t h e b o t t o m
line, Mito operates in motor cooling mode setting the pump to maximum
rpm. From this position, it is possible to start scrolling the various menus
w i t h t h e a r r o w k e y . B y h o l d i n g d o w n t h e " + " k e y , t h e pump is brought to
maximum speed and the dry run protection is by-passed (Use this function
to fill the pump at the first start-up).
Pmax: This parameter is used to set the device set-point at the desidered
pressure value (maximum pressure). During operation, Mito adjusts the
electric pump operation to adapt pump supply to user demand, maintaining
constant pressure in the system. If the Pmax value is set above the pump
maximum head capability, the motor will still stop when taps are turned
Language: it is possible to chose the language in the menus and the alarm
messages. Press the + and – keys to modify the parameter value.
25
1
4
5
3
2