HAMPTON BAY 59299 Guía De Uso Y Mantenimiento página 8

Assembly - Close-to-Ceiling Mount
1
Preparation for mounting
□
Remove the canopy ring (L) from the canopy (C) by turning the
ring to the right until it unlocks.
□
Remove the slide-on mounting plate (A) from the canopy by
loosening the four screws on the top of the canopy (C).
□
Remove the two non-slotted screws (SS) and loosen the
slotted screws. This will enable you to remove the slide-on
mounting bracket (A).
Assembly - Hanging the Fan
4
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or
personal injury, mount to outlet box marked "acceptable
for fan support of 35lbs. (15.9 kg) or less" and use screws
provided with the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting plate on the outlet box by sliding the
mounting bracket (A) over the two screws (JJ) provided with the
outlet box. If necessary, use leveling washers (not included) be-
tween the mounting bracket (A) and the outlet box. Note that the
flat side of the mounting bracket (A) is toward the outlet box.
□
Securely tighten the two mounting screws (JJ).
2
Routing the wires
□
Remove three of the six screws and lock washers (II) (every
other one) securing the motor collar (M) to the top of the fan-
motor housing (D).
□
Place the rubber gasket (EE) over the remaining three screws,
route the wires exiting the top of the fan-motor housing
through the canopy ring (L) (make sure the slot opening are
on top), then proceed to place the ceiling canopy (C) over the
collar at the top of the fan-motor housing (D).
A
□
Align the mounting holes with the holes in the fan-motor
housing (D) and fasten, using the three screws and lock-
washers (II) removed previously. Tighten the mounting screws
securely.
SS
C
L
5
Hanging the fan
□
Carefully lift the fan-motor assembly (D) up to the mounting
bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the slide-on mounting bracket (A) socket. Ensure that the
tab on the slide-on mounting bracket (A) socket is properly
seated in the groove in the hanger ball. If using close-to-
ceiling mounting, hang the fan on the hook provided by
utilizing one of the holes at the outer rim of the ceiling canopy
(C).
A
C
D
8
II
L
WARNING: The hook as shown is only to balance the fan while
attaching wiring. Failure to hang as shown may result in hook
breaking, causing the fan to fall. The hook must pass from
inside to the outside of the canopy.
C
EE
M
D
A
B
C
D