Serial Port - LanParty NFII ULTRA Manual Del Usuario

Serial Port

The serial device (modem, printer) doesn't output anything or
is outputting garbled characters.
1. Make sure that the serial device's power is turned on and that
the device is on-line.
2. Verify that the device is plugged into the correct serial port
on the rear of the computer.
3. Verify that the attached serial device works by attaching it to
a serial port that is working and configured correctly. If the
serial device does not work, either the cable or the serial
device has a problem. If the serial device works, the problem
may be due to the onboard I/O or the address setting.
4. Make sure the COM settings and I/O address are configured
correctly.
Keyboard
Nothing happens when a key on the keyboard was pressed.
1. Make sure the keyboard is properly connected.
2. Make sure there are no objects resting on the keyboard and
that no keys are pressed during the booting process.
System Board
1. Make sure the add-in card is seated securely in the expansion
slot. If the add-in card is loose, power off the system, re-install
the card and power up the system.
2. Check the jumper settings to ensure that the jumpers are
properly set.
3. Verify that all memory modules are seated securely into the
memory sockets.
4. Make sure the memory modules are in the correct locations.
5. If the board fails to function, place the board on a flat surface
and seat all socketed components. Gently press each compo-
nent into the socket.
6. If you made changes to the BIOS settings, re-enter setup and
load the BIOS defaults.
2
English
53