Installing The Cpu - LanParty NFII ULTRA Manual Del Usuario

1.2 Installing the CPU

Warning:
.
.
.
.
.
.
.
.
• Before you install or remove any component, ensure that the
power supply is switched off or the power cord is detached from
the power supply. Failure to do so may cause severe damage to
the system board, peripherals, and/or components.
• Use a grounded wrist strap or touch a safely grounded object or
any metal object before handling the CPU to avoid damage
caused by static electricity.
Gold
mark
Important:
Installing a heat sink with cooling fan is necessary for proper heat
dissipation. Apply a thin layer of thermal paste on top of the CPU.
Failure to do so may result in overheating the CPU.
1. Push the lever sideways, away
Open Up
from the socket, then lift it up to
a 90
"
90 degree
angle
2. Position the CPU above the
Insert and
socket then align the gold mark
press gently
on the corner of the CPU
(designated as pin 1) with pin 1
!
of the socket.
Snap the lever
back into place
3. Inser t the CPU into the socket
until it is seated in place. The CPU
!
will fit in only one orientation
and can easily be inser ted
without exerting any force. Once
the CPU is in place, push down
the lever to lock the socket. The
lever should click on the side tab
to indicate that the CPU is
completely secured in the socket.
Quick Setup Guide
o
angle.
1
7