Philips HD4686/90 Manual De Instrucciones página 12

EnglisH
12
Signal
The kettle beeps once.
The kettle beeps twice.
Problem
I cannot set the desired
temperature.
I try to switch on the
kettle but it switches off
automatically.
The kettle switches off
automatically when
the keep-warm function
is active.
I set the temperature but
the kettle does not work.
I pressed the KEEP
WARM button but the
kettle does not react.
Meaning/solution
The water has reached the set temperature.
The kettle may have switched off at the end of the keep-
warm period (30 minutes). The kettle may also have switched
off because there is too little water in it. Always fill the kettle
with at least 0.5 litres water.
Solution
The current temperature of the water in the kettle is probably the
same or higher than the temperature you want to set. If you wish to
immediately re-heat the water, you can only select 100°c
The kettle has boil-dry protection and automatically switches off
when there is too little water in it. You may need to put more water
in the kettle (at least 0.5 litres).
There may be too little water in the kettle. Always fill the kettle with
at least 0.5 litres water.
The kettle keeps the water warm for 30 minutes and then switches
off automatically. To keep the water hot longer, press the KEEP
WARM button again.
You may not have pressed the on/off button within 10 seconds after
setting the temperature. In this case, the set temperature is lost and
you have to set the temperature again.
The current temperature of the water is probably lower than 80°C
(or 70°C for the beige-wood brown model). First set the desired
keep-warm temperature and then press the KEEP WARM button and
the on/off button (see section 'Keeping water warm' in chapter 'Using
the appliance').