Stiga T8523 Manual Del Propietário página 2

CAUTION:
1. Open the hardware kit and sort all the hardware. For your help
in identifying hardware, see the hardware identifier on page 7.
2. Insert one Caster without Brake #11 and one Caster with Brake
#12 into Caster Beam #14. Be sure casters are inserted all the
way into caster beam. Assemble both caster beams and casters
the same way. See Figure 1.
3. Attach two Upright Tubes #15 to each Caster Beam #14 using
two Carriage Bolts #28, two washers #29 and two locknuts
#26 in each tube. See Figure 2. Tighten nuts but do not
overtighten, cracking the plastic.
4. Attach one Safety Latch #19 in the right hand hole of a Name
Panel #17 as shown in Figures 3 and 3A. Attach with one screw
#24, one washer #25 and one locknut #23. NOTE: Safety
latch must be installed exactly as shown, with flange
on safety latch over top of name panel.
IMPORTANT: Do not overtighten locknuts. Latches #19 must
pivot freely. When latch is pivoted, it must freely fall back
to original position when released.
Assemble the other safety latch #19 to the other name
panel #17 in exactly the same way.
CAUTION:
INSTALL SAFETY LATCHES EXACTLY AS
SHOWN. DO NOT SKIP THIS STEP . DO NOT
OPERATE TABLE WITHOUT SAFETY LATCHES
INSTALLED.
Figure 3
AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE ASSEMBLY!
DO NOT LEAVE TABLE UNATTENDED UNTIL ASSEMBLY IS
COMPLETE!
2
Figure 1
Figure 2
Figure 3A