Stiga T8523 Manual Del Propietário página 4

CAUTION:
8. When doing this step, you may want to place a towel between
table top and wall to keep from scratching wall. With the help of
at least one other adult, take either table half #1 and lean it
against a wall as shown in Figure 6. Turn top so that it is positioned
as shown.
NOTE: If you desire, table can be placed on the floor, if
carpeted, or on the shipping carton, with the playing
surface down. Be careful not to damage the playing
surface.
9. Attach Leg Assembly #9 to Brackets #6 on the bottom of table
half #1. See Figure 6 and Detail A. Use two bolts #30, four
washers #27 and two locknuts #26. NOTE: Washers #27
go on both sides of leg. NOTE: Cross Brace on Leg
Assembly goes against table.
Tighten locknuts snug, but do not overtighten. Leg must pivot in
brackets.
AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE
FOLLOWING STEPS!
4
4
10. Screw a Leg Leveler #13 into end of each leg on leg assembly
#9. See Figure 6.
11. Attach Linkages #16 to inside of legs #9 using bolts #31,
Spacers #20 and Locknuts #26. NOTE: Spacer #20 goes
between leg and linkage. See Figure 6 and Detail B.
Tighten locknuts snug, but do not overtighten. Joint must be
able to move.
12. You are now done assembling parts to the first table half.
Repeat steps 8 – 11 on second table half.
Figure 6