Stiga T8523 Manual Del Propietário página 5

CAUTION:
1
22
15
21
13. Place a Hex Bolt #22, a Washer #27 and a Locknut #26 on
the floor next to all four caster wheels on both sides of base
assembly you put together earlier.
14. Make sure the leg assembly #9 on the first table half is open
and linkages #16 are pointing toward middle of table. See
Figure 7. With one adult person on each side of the table, lift
and set table half on its legs.
CAUTION:
TABLE HALF WILL NOT STAND ON ITS OWN,
YOU MUST HOLD IT UP!
Brace table half against a wall to help stabilize it. Be sure that
there is enough room to connect second half.
UNTIL THE TABLE HALVES ARE CONNECTED THEY WILL NOT STAND ON THEIR
OWN. IT IS RECOMMENDED TO HAVE THREE PEOPLE TO CONNECT TABLE
HALVES. TWO TO STABILIZE TABLE AND ONE TO BOLT TABLE TOGETHER.
6
26
9
27
20
16
15
16
26
While holding table half up, pull the base assembly under this
half until the hole in Upright Tube #15 is aligned with lower
middle hole in the Mounting Bracket #6 on the bottom of
table half. See Figure 7 and Detail A. Attach Upright Tubes
#15 to Mounting Brackets #6 with Hex Bolts #22, Washers
#27 and Locknuts #26 that you placed on floor in step 13.
15. Remove bottom bolts #21 from bottom holes that attach name
panels to Upright Tubes. Attach end of Linkage #16 to outside
of Upright Tube #15 with bolt #21 (that you just removed),
spacer #20 and Locknut #26. Note spacer #20 goes between
linkage #16 and upright tube #15. See Figure 7 and Detail
B. Tighten all nuts snug, but do not overtighten. Joints must
pivot.
CAUTION:
DO NOT ATTEMPT TO RAISE THIS HALF UP TO
STORAGE POSITION UNTIL OTHER HALF TOP
IS ATTACHED AND YOU HAVE READ AND
UNDERSTAND ALL OPERATING INSTRUCTIONS.
5
Figure 7